On Mon, 25 Dec 2000, Manfred wrote:
> Could you try this setup?
> <<<<<<<<
> /* Configure the PCI bus bursts and FIFO thresholds. */
> /* Configure for standard, in-spec Ethernet. */
> np->tx_config = (1<<28) + /* Automatic transmit padding */
> (1<<23) + /* Excessive collision retry */
> (6<<20) + /* Max DMA burst = 128 byte */
> (8<<8) + /* fill threshold = 256 byte */
> 8; /* drain threshold = 256 byte */
> writel(np->tx_config, ioaddr + TxConfig);
> >>>>>>>>
Hmm, that little change worked a lot better. However thoughput is down to
700kb/s! Transferring files from the other machine to this machine is much
faster - 868kb/s.
In the logs, I only got *one* message from the natsemi driver (and this
happened when sending files from this machine to the other machine. No
problems receiving from the other machine.
Dec 25 17:28:12 tahallah kernel: eth0: Something Wicked happened! 0583.
But I just realised that the other machine I'm using has an 10 megabit
ethernet card (on the hub that one is shown on 10, my machine is shown as
100). I think this explains the throughput problem. When I get another 4
way power socket, I'll put my other machine (which has a 100 megabit card
in it) on the network and see if that makes a difference.
Cheers,
Alex
--
Huffapuff!
http://www.tahallah.clara.co.uk
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
