Rename to be coherent with the datasheet.
Signed-off-by: Christina Quast <cqu...@hanoverdisplays.com>
---
drivers/tty/serial/imx.c | 24 ++++++++++++------------
1 file changed, 12 insertions(+), 12 deletions(-)
diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
index dff75dc94731..8edb368690d9 100644
--- a/drivers/tty/serial/imx.c
+++ b/drivers/tty/serial/imx.c
@@ -39,8 +39,8 @@
#include "serial_mctrl_gpio.h"
/* Register definitions */
-#define URXD0 0x0 /* Receiver Register */
-#define URTX0 0x40 /* Transmitter Register */
+#define URXD 0x0 /* Receiver Register */
+#define UTXD 0x40 /* Transmitter Register */
#define UCR1 0x80 /* Control Register 1 */
#define UCR2 0x84 /* Control Register 2 */
#define UCR3 0x88 /* Control Register 3 */
@@ -502,7 +502,7 @@ static inline void imx_uart_transmit_buffer(struct imx_port
*sport)
if (sport->port.x_char) {
/* Send next char */
- imx_uart_writel(sport, sport->port.x_char, URTX0);
+ imx_uart_writel(sport, sport->port.x_char, UTXD);
sport->port.icount.tx++;
sport->port.x_char = 0;
return;
@@ -536,7 +536,7 @@ static inline void imx_uart_transmit_buffer(struct imx_port
*sport)
!(imx_uart_readl(sport, imx_uart_uts_reg(sport)) & UTS_TXFULL)) {
/* send xmit->buf[xmit->tail]
* out the port here */
- imx_uart_writel(sport, xmit->buf[xmit->tail], URTX0);
+ imx_uart_writel(sport, xmit->buf[xmit->tail], UTXD);
xmit->tail = (xmit->tail + 1) & (UART_XMIT_SIZE - 1);
sport->port.icount.tx++;
}
@@ -743,7 +743,7 @@ static irqreturn_t imx_uart_rxint(int irq, void *dev_id)
flg = TTY_NORMAL;
sport->port.icount.rx++;
- rx = imx_uart_readl(sport, URXD0);
+ rx = imx_uart_readl(sport, URXD);
usr2 = imx_uart_readl(sport, USR2);
if (usr2 & USR2_BRCD) {
@@ -870,7 +870,7 @@ static irqreturn_t imx_uart_int(int irq, void *dev_id)
* the respective irq source is enabled. This prevents some undesired
* actions, for example if a character that sits in the RX FIFO and that
* should be fetched via DMA is tried to be fetched using PIO. Or the
- * receiver is currently off and so reading from URXD0 results in an
+ * receiver is currently off and so reading from URXD results in an
* exception. So just mask the (raw) status bits for disabled irqs.
*/
if ((ucr1 & UCR1_RRDYEN) == 0)
@@ -1231,7 +1231,7 @@ static int imx_uart_dma_init(struct imx_port *sport)
}
slave_config.direction = DMA_DEV_TO_MEM;
- slave_config.src_addr = sport->port.mapbase + URXD0;
+ slave_config.src_addr = sport->port.mapbase + URXD;
slave_config.src_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE;
/* one byte less than the watermark level to enable the aging timer */
slave_config.src_maxburst = RXTL_DMA - 1;
@@ -1257,7 +1257,7 @@ static int imx_uart_dma_init(struct imx_port *sport)
}
slave_config.direction = DMA_MEM_TO_DEV;
- slave_config.dst_addr = sport->port.mapbase + URTX0;
+ slave_config.dst_addr = sport->port.mapbase + UTXD;
slave_config.dst_addr_width = DMA_SLAVE_BUSWIDTH_1_BYTE;
slave_config.dst_maxburst = TXTL_DMA;
ret = dmaengine_slave_config(sport->dma_chan_tx, &slave_config);
@@ -1798,7 +1798,7 @@ static int imx_uart_poll_get_char(struct uart_port *port)
if (!(imx_uart_readl(sport, USR2) & USR2_RDR))
return NO_POLL_CHAR;
- return imx_uart_readl(sport, URXD0) & URXD_RX_DATA;
+ return imx_uart_readl(sport, URXD) & URXD_RX_DATA;
}
static void imx_uart_poll_put_char(struct uart_port *port, unsigned char c)
@@ -1812,7 +1812,7 @@ static void imx_uart_poll_put_char(struct uart_port
*port, unsigned char c)
} while (~status & USR1_TRDY);
/* write */
- imx_uart_writel(sport, c, URTX0);
+ imx_uart_writel(sport, c, UTXD);
/* flush */
do {
@@ -1894,7 +1894,7 @@ static void imx_uart_console_putchar(struct uart_port
*port, int ch)
while (imx_uart_readl(sport, imx_uart_uts_reg(sport)) & UTS_TXFULL)
barrier();
- imx_uart_writel(sport, ch, URTX0);
+ imx_uart_writel(sport, ch, UTXD);
}
/*
@@ -2091,7 +2091,7 @@ static void imx_uart_console_early_putchar(struct
uart_port *port, int ch)
while (imx_uart_readl(sport, IMX21_UTS) & UTS_TXFULL)
cpu_relax();
- imx_uart_writel(sport, ch, URTX0);
+ imx_uart_writel(sport, ch, UTXD);
}
static void imx_uart_console_early_write(struct console *con, const char *s,
--
2.20.1
Please consider the environment before printing this email
The information transmitted is intended only for the person or entity to which
it is addressed and may contain confidential and/or privileged material. Any
review, retransmission, dissemination or other use of, or taking of any action
in reliance upon, this information by persons or entities other than the
intended recipient is prohibited.
If you received this in error, please contact the sender or postmaster
(postmas...@hanoverdisplays.com) and delete the material from any computer.
Although we routinely screen for viruses, addressees should check this e-mail
and any attachment for viruses. We make no warranty as to absence of viruses in
this e-mail or any attachments.
Our Company's email policy is to permit incidental personal use. If this email
is of a personal nature, it must not be relied upon as expressing the views or
opinions of the company.
