Current version of the driver was configuring XLG MAC
in a way to wait 3 IDLE frames before allowing for the
link-up interrupt to be triggered. This resulted in an
issue, preventing to detect the link change during RX
traffic on the interface. Fix that.
Fixes: 4bb043262878 ("net: mvpp2: phylink support")
Signed-off-by: Marcin Wojtas <m...@semihalf.com>
---
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 3 +--
1 file changed, 1 insertion(+), 2 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 16066c2..f1378f9 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -4532,8 +4532,7 @@ static void mvpp2_xlg_config(struct mvpp2_port *port,
unsigned int mode,
ctrl0 |= MVPP22_XLG_CTRL0_RX_FLOW_CTRL_EN;
ctrl4 &= ~MVPP22_XLG_CTRL4_MACMODSELECT_GMAC;
- ctrl4 |= MVPP22_XLG_CTRL4_FWD_FC | MVPP22_XLG_CTRL4_FWD_PFC |
- MVPP22_XLG_CTRL4_EN_IDLE_CHECK;
+ ctrl4 |= MVPP22_XLG_CTRL4_FWD_FC | MVPP22_XLG_CTRL4_FWD_PFC;
writel(ctrl0, port->base + MVPP22_XLG_CTRL0_REG);
writel(ctrl4, port->base + MVPP22_XLG_CTRL4_REG);
--
2.7.4
