On Tue, 2019-01-29 at 16:36 -0200, Lucas Oshiro wrote:
> Solve most of the checkpatch.pl WARNINGs and CHECKs on lmp9100.c. They
> are the following:
>
> lmp91000.c:116: CHECK: Unnecessary parentheses around 'state != channel'
> lmp91000.c:116: CHECK: Unnecessary parentheses around 'channel ==
> LMP91000_REG_MODECN_TEMP'
> lmp91000.c:214: CHECK: braces {} should be used on all arms of this statement
> lmp91000.c:216: CHECK: Unbalanced braces around else statement
> lmp91000.c:258: WARNING: line over 80 characters
> lmp91000.c:279: CHECK: Please don't use multiple blank lines
Some will say this is too many things to do at once.
I think it's mostly fine, but there are a few nits
that also could use fixing.
> diff --git a/drivers/iio/potentiostat/lmp91000.c
> b/drivers/iio/potentiostat/lmp91000.c
[]
> @@ -211,9 +211,9 @@ static int lmp91000_read_config(struct lmp91000_data
> *data)
>
> ret = of_property_read_u32(np, "ti,tia-gain-ohm", &val);
> if (ret) {
> - if (of_property_read_bool(np, "ti,external-tia-resistor"))
> + if (of_property_read_bool(np, "ti,external-tia-resistor")) {
> val = 0;
> - else {
> + } else {
> dev_err(dev, "no ti,tia-gain-ohm defined");
> return ret;
> }
This could use inverting the test
if (ret) {
if (!of_property_read_bool(...)) {
dev_err(dev, "no ti,ti-gain-ohm defined\n");
return ret;
}
val = 0;
}
Also the dev_err is missing a '\n' termination
