Hello, I'm using the emu10k1 module with my SB Live. This works quite fine, but I cannot switch the recording channel. This worked with 2.2.17. Now volume works, but selecting the input channel not anymore. is anyone else experiencing this problem , or don't i just get the right setting? second, i habe 2 nics in my K6-2 system, both with rtl8139 chip and compiled 8139oo into the kernel. the cards work fine, but dmesg says: eth0: Abnormal interrupt, status 00002002 and eth0: Abnormal interrupt, status 00000020 endless times. Usually about 2-3 entries per minute. The cards work fine, so how can I get rid of the message, other then uncommenting the line in the source code? This also happens if I compile the driver as module. And happened sind 2.4.0-test12 (the first 2.4.0er I installed). This is my first post on this list. If you need additional information, I'd like to provide it. So far, Jan - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] Please read the FAQ at http://www.tux.org/lkml/
