On 28/01/2019 12:47, Mark Brown wrote:
On Mon, Jan 28, 2019 at 08:41:05AM +0100, Geert Uytterhoeven wrote:
On Sat, Jan 26, 2019 at 4:40 PM Jonas Bonn <jo...@norrbonn.se> wrote:
spi-3wire: again, only set by MAXIM DS-1302 which always needs this
setting; driver could set this
For DS1302, this is probable true.
Some devices may support both 4-wire or 3-wire mode?
IIRC yes.
Just for the record, the datasheet says it's exclusively 3-wire. But
it's not important...
/Jonas
Yeah, that one make sense. But if the DT is only overriding the maximum
device frequency that the driver should otherwise be setting, why is
spi-max-frequency a _required_ property?
That's a good question. Legacy?
It's a documentation error.
