Hi Steve,

On Sat, Jan 19, 2019 at 7:19 PM Steve Longerbeam <slongerb...@gmail.com> wrote:
>
> Add video capture support from the OV5642 to IPU CSI0 on
> the i.MX53 SMD.
>
> Signed-off-by: Steve Longerbeam <slongerb...@gmail.com>
Looks good, thanks:

Reviewed-by: Fabio Estevam <feste...@gmail.com>

Only one minor nit below that perhaps Shawn could adjust while applying:

     pmic: dialog@48 {
>                 compatible = "dlg,da9053", "dlg,da9052";
>                 reg = <0x48>;
> +               interrupt-parent = <&gpio7>;
> +               interrupts = <11 IRQ_TYPE_LEVEL_LOW>; /* low-level active IRQ 
> at GPIO7_11 */
> +
> +               regulators {
> +                       ldo7_reg: ldo7 {
> +                               regulator-min-microvolt = <1200000>;
> +                               regulator-max-microvolt = <3600000>;
> +                               regulator-always-on;
> +                       };
> +
> +                       ldo9_reg: ldo9 {
> +                               regulator-min-microvolt = <1250000>;
> +                               regulator-max-microvolt = <3650000>;
> +                               regulator-always-on;

regulator-always-on could be removed from the two regulators above
since they are used by the camera.

Reply via email to