Add interrupt controller properties now that spmi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.
This change was not tested on any hardware but the same change was
tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with
no issues.
Signed-off-by: Brian Masney <masn...@onstation.org>
Reviewed-by: Stephen Boyd <sb...@kernel.org>
Reviewed-by: Bjorn Andersson <bjorn.anders...@linaro.org>
---
Changes since v4:
- None
Patch introduced in v4.
arch/arm64/boot/dts/qcom/pmi8994.dtsi | 12 ++----------
1 file changed, 2 insertions(+), 10 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/pmi8994.dtsi
b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
index dae1cdc23f54..3aee10e3f921 100644
--- a/arch/arm64/boot/dts/qcom/pmi8994.dtsi
+++ b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
@@ -15,16 +15,8 @@
reg = <0xc000>;
gpio-controller;
#gpio-cells = <2>;
- interrupts = <2 0xc0 0 IRQ_TYPE_NONE>,
- <2 0xc1 0 IRQ_TYPE_NONE>,
- <2 0xc2 0 IRQ_TYPE_NONE>,
- <2 0xc3 0 IRQ_TYPE_NONE>,
- <2 0xc4 0 IRQ_TYPE_NONE>,
- <2 0xc5 0 IRQ_TYPE_NONE>,
- <2 0xc6 0 IRQ_TYPE_NONE>,
- <2 0xc7 0 IRQ_TYPE_NONE>,
- <2 0xc8 0 IRQ_TYPE_NONE>,
- <2 0xc9 0 IRQ_TYPE_NONE>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
};
};
--
2.17.2
