From: Antoine Tenart <antoine.ten...@bootlin.com>
[ Upstream commit 1b451fb2051b464b9758c09a3492104403252e2b ]
The mvpp2_phylink_validate() sets all modes that are supported by a
given PPv2 port. An mistake made the 10000baseT_Full mode being
advertised in some cases when a port wasn't configured to perform at
10G. This patch fixes this.
Fixes: d97c9f4ab000 ("net: mvpp2: 1000baseX support")
Reported-by: Russell King <li...@armlinux.org.uk>
Signed-off-by: Antoine Tenart <antoine.ten...@bootlin.com>
Signed-off-by: David S. Miller <da...@davemloft.net>
Signed-off-by: Sasha Levin <sas...@kernel.org>
---
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index d5bc90476b4f..f8e4808a8317 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -4293,6 +4293,7 @@ static void mvpp2_phylink_validate(struct net_device *dev,
case PHY_INTERFACE_MODE_XAUI:
case PHY_INTERFACE_MODE_NA:
if (port->gop_id == 0) {
+ phylink_set(mask, 10000baseT_Full);
phylink_set(mask, 10000baseCR_Full);
phylink_set(mask, 10000baseSR_Full);
phylink_set(mask, 10000baseLR_Full);
@@ -4310,7 +4311,6 @@ static void mvpp2_phylink_validate(struct net_device *dev,
phylink_set(mask, 10baseT_Full);
phylink_set(mask, 100baseT_Half);
phylink_set(mask, 100baseT_Full);
- phylink_set(mask, 10000baseT_Full);
/* Fall-through */
case PHY_INTERFACE_MODE_1000BASEX:
case PHY_INTERFACE_MODE_2500BASEX:
--
2.19.1
