Programs initial drive code offsets which will be used by auto
calibration process.
Programs fixed drive strengths for SDMMC pads when auto cal
timeouts. Fixed settings are based on Pre-SI analysis of the
pad design.
Signed-off-by: Sowjanya Komatineni <skomatin...@nvidia.com>
---
drivers/mmc/host/sdhci-tegra.c | 112 ++++++++++++++++++++++++++++++-----------
1 file changed, 84 insertions(+), 28 deletions(-)
diff --git a/drivers/mmc/host/sdhci-tegra.c b/drivers/mmc/host/sdhci-tegra.c
index 7b95d088fdef..2524654282d1 100644
--- a/drivers/mmc/host/sdhci-tegra.c
+++ b/drivers/mmc/host/sdhci-tegra.c
@@ -75,6 +75,7 @@
#define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_VREF_SEL_MASK 0x0000000f
#define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_VREF_SEL_VAL 0x7
#define SDHCI_TEGRA_SDMEM_COMP_PADCTRL_E_INPUT_E_PWRD BIT(31)
+#define SDHCI_COMP_PADCTRL_DRVUPDN_OFFSET_MASK 0x07FFF000
#define SDHCI_TEGRA_AUTO_CAL_STATUS 0x1ec
#define SDHCI_TEGRA_AUTO_CAL_ACTIVE BIT(31)
@@ -121,6 +122,8 @@ struct sdhci_tegra {
struct pinctrl *pinctrl_sdmmc;
struct pinctrl_state *pinctrl_state_3v3;
struct pinctrl_state *pinctrl_state_1v8;
+ struct pinctrl_state *pinctrl_state_3v3_drv;
+ struct pinctrl_state *pinctrl_state_1v8_drv;
struct sdhci_tegra_autocal_offsets autocal_offsets;
ktime_t last_calib;
@@ -130,6 +133,9 @@ struct sdhci_tegra {
u32 dqs_trim;
};
+static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage,
+ bool state_drvupdn);
+
static u16 tegra_sdhci_readw(struct sdhci_host *host, int reg)
{
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
@@ -437,6 +443,7 @@ static void tegra_sdhci_pad_autocalib(struct sdhci_host
*host)
pdpu = offsets.pull_down_3v3 << 8 | offsets.pull_up_3v3;
}
+ /* Set initial offset before auto-calibration */
tegra_sdhci_set_pad_autocal_offset(host, pdpu);
card_clk_enabled = tegra_sdhci_configure_card_clk(host, false);
@@ -460,19 +467,15 @@ static void tegra_sdhci_pad_autocalib(struct sdhci_host
*host)
if (ret) {
dev_err(mmc_dev(host->mmc), "Pad autocal timed out\n");
- if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_180)
- pdpu = offsets.pull_down_1v8_timeout << 8 |
- offsets.pull_up_1v8_timeout;
- else
- pdpu = offsets.pull_down_3v3_timeout << 8 |
- offsets.pull_up_3v3_timeout;
-
- /* Disable automatic calibration and use fixed offsets */
+ /* Disable automatic cal and use fixed Drive Strengths */
reg = sdhci_readl(host, SDHCI_TEGRA_AUTO_CAL_CONFIG);
reg &= ~SDHCI_AUTO_CAL_ENABLE;
sdhci_writel(host, reg, SDHCI_TEGRA_AUTO_CAL_CONFIG);
- tegra_sdhci_set_pad_autocal_offset(host, pdpu);
+ ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, false);
+ if (ret < 0)
+ dev_err(mmc_dev(host->mmc),
+ "Setting drive strengths failed %d\n", PTR_ERR(ret));
}
}
@@ -743,27 +746,73 @@ static int tegra_sdhci_execute_tuning(struct sdhci_host
*host, u32 opcode)
return mmc_send_tuning(host->mmc, opcode, NULL);
}
-static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage)
+static int tegra_sdhci_set_padctrl(struct sdhci_host *host, int voltage,
+ bool state_drvupdn)
{
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
struct sdhci_tegra *tegra_host = sdhci_pltfm_priv(pltfm_host);
- int ret;
+ struct sdhci_tegra_autocal_offsets offsets =
+ tegra_host->autocal_offsets;
+ struct pinctrl_state *pinctrl_drvupdn = NULL;
+ int ret = 0;
+ u8 drvup = 0, drvdn = 0;
+ u32 reg;
- if (!tegra_host->pad_control_available)
- return 0;
+ if (!state_drvupdn) {
+ /* PADS Drive Strength */
+ if (voltage == MMC_SIGNAL_VOLTAGE_180) {
+ if (!IS_ERR(tegra_host->pinctrl_state_1v8_drv) &&
+ (tegra_host->pinctrl_state_1v8_drv != NULL)) {
+ pinctrl_drvupdn =
+ tegra_host->pinctrl_state_1v8_drv;
+ } else {
+ drvup = offsets.pull_up_1v8_timeout;
+ drvdn = offsets.pull_down_1v8_timeout;
+ }
+ } else {
+ if (!IS_ERR(tegra_host->pinctrl_state_3v3_drv) &&
+ (tegra_host->pinctrl_state_3v3_drv != NULL)) {
+ pinctrl_drvupdn =
+ tegra_host->pinctrl_state_3v3_drv;
+ } else {
+ drvup = offsets.pull_up_3v3_timeout;
+ drvdn = offsets.pull_down_3v3_timeout;
+ }
+ }
+
+ if (pinctrl_drvupdn != NULL) {
+ ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+ pinctrl_drvupdn);
+ if (ret < 0)
+ dev_err(mmc_dev(host->mmc),
+ "failed pads drvupdn, ret: %d\n", ret);
+ } else if ((drvup) || (drvdn)) {
+ reg = sdhci_readl(host,
+ SDHCI_TEGRA_SDMEM_COMP_PADCTRL);
+ reg &= ~SDHCI_COMP_PADCTRL_DRVUPDN_OFFSET_MASK;
+ reg |= (drvup << 20) | (drvdn << 12);
+ sdhci_writel(host, reg,
+ SDHCI_TEGRA_SDMEM_COMP_PADCTRL);
+ }
- if (voltage == MMC_SIGNAL_VOLTAGE_180) {
- ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
- tegra_host->pinctrl_state_1v8);
- if (ret < 0)
- dev_err(mmc_dev(host->mmc),
- "setting 1.8V failed, ret: %d\n", ret);
} else {
- ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
- tegra_host->pinctrl_state_3v3);
- if (ret < 0)
- dev_err(mmc_dev(host->mmc),
- "setting 3.3V failed, ret: %d\n", ret);
+ /* Dual Voltage PADS Voltage selection */
+ if (!tegra_host->pad_control_available)
+ return 0;
+
+ if (voltage == MMC_SIGNAL_VOLTAGE_180) {
+ ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+ tegra_host->pinctrl_state_1v8);
+ if (ret < 0)
+ dev_err(mmc_dev(host->mmc),
+ "setting 1.8V failed, ret: %d\n", ret);
+ } else {
+ ret = pinctrl_select_state(tegra_host->pinctrl_sdmmc,
+ tegra_host->pinctrl_state_3v3);
+ if (ret < 0)
+ dev_err(mmc_dev(host->mmc),
+ "setting 3.3V failed, ret: %d\n", ret);
+ }
}
return ret;
@@ -778,7 +827,7 @@ static int sdhci_tegra_start_signal_voltage_switch(struct
mmc_host *mmc,
int ret = 0;
if (ios->signal_voltage == MMC_SIGNAL_VOLTAGE_330) {
- ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage);
+ ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, true);
if (ret < 0)
return ret;
ret = sdhci_start_signal_voltage_switch(mmc, ios);
@@ -786,7 +835,7 @@ static int sdhci_tegra_start_signal_voltage_switch(struct
mmc_host *mmc,
ret = sdhci_start_signal_voltage_switch(mmc, ios);
if (ret < 0)
return ret;
- ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage);
+ ret = tegra_sdhci_set_padctrl(host, ios->signal_voltage, true);
}
if (tegra_host->pad_calib_required)
@@ -805,8 +854,15 @@ static int tegra_sdhci_init_pinctrl_info(struct device
*dev,
return -1;
}
- tegra_host->pinctrl_state_3v3 =
- pinctrl_lookup_state(tegra_host->pinctrl_sdmmc, "sdmmc-3v3");
+ tegra_host->pinctrl_state_1v8_drv = pinctrl_lookup_state(
+ tegra_host->pinctrl_sdmmc, "sdmmc-1v8-drv");
+
+ tegra_host->pinctrl_state_3v3_drv = pinctrl_lookup_state(
+ tegra_host->pinctrl_sdmmc, "sdmmc-3v3-drv");
+
+ tegra_host->pinctrl_state_3v3 = pinctrl_lookup_state(
+ tegra_host->pinctrl_sdmmc, "sdmmc-3v3");
+
if (IS_ERR(tegra_host->pinctrl_state_3v3)) {
dev_warn(dev, "Missing 3.3V pad state, err: %ld\n",
PTR_ERR(tegra_host->pinctrl_state_3v3));
--
2.7.4
