The mvpp2_phylink_validate() function sets all modes that are
supported by a given PPv2 port. A recent change made all ports to
advertise they support 10G modes in certain cases. This is not true,
as only the port #0 can do so. This patch fixes it.
Fixes: 01b3fd5ac97c ("net: mvpp2: fix detection of 10G SFP modules")
Cc: Baruch Siach <bar...@tkos.co.il>
Signed-off-by: Antoine Tenart <antoine.ten...@bootlin.com>
---
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 14 ++++++++------
1 file changed, 8 insertions(+), 6 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index 125ea99418df..88aa488054a8 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -4405,12 +4405,14 @@ static void mvpp2_phylink_validate(struct net_device
*dev,
case PHY_INTERFACE_MODE_10GKR:
case PHY_INTERFACE_MODE_XAUI:
case PHY_INTERFACE_MODE_NA:
- phylink_set(mask, 10000baseCR_Full);
- phylink_set(mask, 10000baseSR_Full);
- phylink_set(mask, 10000baseLR_Full);
- phylink_set(mask, 10000baseLRM_Full);
- phylink_set(mask, 10000baseER_Full);
- phylink_set(mask, 10000baseKR_Full);
+ if (port->gop_id == 0) {
+ phylink_set(mask, 10000baseCR_Full);
+ phylink_set(mask, 10000baseSR_Full);
+ phylink_set(mask, 10000baseLR_Full);
+ phylink_set(mask, 10000baseLRM_Full);
+ phylink_set(mask, 10000baseER_Full);
+ phylink_set(mask, 10000baseKR_Full);
+ }
/* Fall-through */
case PHY_INTERFACE_MODE_RGMII:
case PHY_INTERFACE_MODE_RGMII_ID:
--
2.19.2
