Hi Alexandre,
On Fri, Dec 7, 2018 at 10:34 AM Alexandre Belloni
<alexandre.bell...@bootlin.com> wrote:
> On 06/12/2018 11:36:59+0100, Geert Uytterhoeven wrote:
> > > +The following properties may not be supported by all drivers. However,
> > > if a
> > > +driver wants to support one of the below features, it should adapt the
> > > bindings
> > > +below.
> > > +- trickle-resistor-ohms : Selected resistor for trickle charger. Should
> > > be given
> >
> > Can this resistor be less than 1 ohm?
> > trickle-resistor-milli-ohms?
>
> Well, this is what current drivers already use so we are stuck with that
> for now.
>
> The value should be a few kOhm anyway. I think the lowest I know about
> is 250 Ohm.
OK, good to know. Thanks!
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- ge...@linux-m68k.org
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
