Hi,
Thank you for your comments.
On 2018/12/05 8:11, Rob Herring wrote:
On Mon, Nov 19, 2018 at 10:02:12AM +0900, Sugaya Taichi wrote:
Add DT bindings document for Milbeaut M10V pinctrl.
Signed-off-by: Sugaya Taichi <sugaya.tai...@socionext.com>
---
.../pinctrl/socionext,milbeaut-pinctrl.txt | 33 ++++++++++++++++++++++
1 file changed, 33 insertions(+)
create mode 100644
Documentation/devicetree/bindings/pinctrl/socionext,milbeaut-pinctrl.txt
diff --git
a/Documentation/devicetree/bindings/pinctrl/socionext,milbeaut-pinctrl.txt
b/Documentation/devicetree/bindings/pinctrl/socionext,milbeaut-pinctrl.txt
new file mode 100644
index 0000000..7469189
--- /dev/null
+++ b/Documentation/devicetree/bindings/pinctrl/socionext,milbeaut-pinctrl.txt
@@ -0,0 +1,33 @@
+Milbeaut SoCs pin controller
+
+Required properties:
+- compatible: should be one of the following:
+ "socionext,milbeaut-m10v-pinctrl" - for m10v SoC
+- reg: offset and length of the register set.
+- reg-names: should be "pinctrl", "exiu".
+- gpio-cells; should be 2.
#gpio-cells
gpio-controller?
Ah yes. I forgot to add it.
Add it.
+- interrupt-cells: should be 2.
#interrupt-cells
interrupt-controller?
Add it also.
Thanks,
Sugaya Taichi
+- clocks: phandle to the input clock.
+- interrupts: three interrupts specifer.
+- interrupt-names: corresponds "interrupts" factor.
+
+Example:
+ pinctrl: pinctrl@1d022000 {
+ compatible = "socionext,milbeaut-m10v-pinctrl";
+ reg = <0x1d022000 0x1000>,
+ <0x1c26f000 0x1000>;
+ reg-names = "pinctrl", "exiu";
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ clocks = <&dummy_clk>;
+ interrupts = <0 54 4>, <0 55 4>, <0 56 4>, <0 57 4>,
+ <0 58 4>, <0 59 4>, <0 60 4>, <0 61 4>,
+ <0 62 4>, <0 63 4>, <0 64 4>, <0 65 4>,
+ <0 66 4>, <0 67 4>, <0 68 4>, <0 69 4>;
+ interrupt-names = "pin-48", "pin-49", "pin-50", "pin-51",
+ "pin-52", "pin-53", "pin-54", "pin-55",
+ "pin-56", "pin-57", "pin-58", "pin-59",
+ "pin-60", "pin-61", "pin-62", "pin-63";
+ }
--
1.9.1
