Hi Boris, > -----Original Message----- > From: Boris Brezillon [mailto:boris.brezil...@bootlin.com] > Sent: Monday, December 3, 2018 1:35 PM > To: Yogesh Narayan Gaur <yogeshnarayan.g...@nxp.com>; > broo...@kernel.org > Cc: linux-...@lists.infradead.org; marek.va...@gmail.com; vigne...@ti.com; > linux-...@vger.kernel.org; devicet...@vger.kernel.org; r...@kernel.org; > mark.rutl...@arm.com; shawn...@kernel.org; linux-arm- > ker...@lists.infradead.org; computersforpe...@gmail.com; > frieder.schre...@exceet.de; linux-kernel@vger.kernel.org > Subject: Re: [PATCH v4 1/7] spi: add support for octo mode I/O data transfer > > Hi Yogesh, > > On Thu, 22 Nov 2018 05:14:31 +0000 > Yogesh Narayan Gaur <yogeshnarayan.g...@nxp.com> wrote: > > > Add flags for Octo mode I/O data transfer Required for the SPI > > controller which can do the data transfer (TX/RX) on 8 data lines e.g. > > NXP FlexSPI controller. > > SPI_TX_OCTO: transmit with 8 wires > > SPI_RX_OCTO: receive with 8 wires > > > > Signed-off-by: Yogesh Gaur <yogeshnarayan.g...@nxp.com> > > Reviewed-by: Boris Brezillon <boris.brezil...@bootlin.com> > > --- > > Changes for v4: > > - Rebase on top of v4.20-rc2 > > Changes for v3: > > - Modified string 'octal' with 'octo'. > > When I listed the differences between your version and mine, I mentioned the > OCTO vs OCTAL name, but I didn't say my decision was the correct one :-). > Looks > like OCTAL is the term employed almost everywhere, and it's also consistent > with DUAL. Would you mind sending a new version reverting the name to OCTAL. > Next version of patch series send [1]
-- Regards, Yogesh Gaur [1] https://patchwork.ozlabs.org/project/linux-mtd/list/?series=79338 [...]
