Hi, for a customer we are operating a rackful of HP/DL380/G4 boxes that have given us some problems with system responsiveness under [I/O triggered] system load.
The systems in question have the following HW: 2x Intel/EM64T CPUs 8GB memory CCISS Raid controller with 4x72GB SCSI disks as RAID5 2x BCM5704 NIC (using tg3) The distribution is RHEL4. We have tested several kernels including the original 2.6.9, 2.6.19.2, 2.6.22-rc7 and 2.6.22-rc7+cfs-v18. One part of the workload is when several processes try to write 5 GB each to the local filesystem (ext2->LVM->CCISS). When this happens, the load goes up to 12 and responsiveness goes down. This means from one moment to the next things like opening a ssh connection to the host in question, or doing "df" take forever (minutes). Especially bad with the vendor kernel, better (but not perfect) with 2.6.19 and 2.6.22-rc7. The load basically comes from the writing processes and up to 12 "pdflush" threads all being in "D" state. So, what I would like to understand is how we can maximize the responsiveness of the system, while keeping disk throughput at maximum. During my investiogation I basically performed the following test, because it represents the kind of trouble situation: ---- $ cat dd3.sh echo "Start 3 dd processes: "`date` dd if=/dev/zero of=/scratch/X1 bs=1M count=5000& dd if=/dev/zero of=/scratch/X2 bs=1M count=5000& dd if=/dev/zero of=/scratch/X3 bs=1M count=5000& wait echo "Finish 3 dd processes: "`date` sync echo "Finish sync: "`date` rm -f /scratch/X? echo "Files removed: "`date` ---- This results in the following timings. All with the anticipatory scheduler, because it gives the best results: 2.6.19.2, HT: 10m 2.6.19.2, non-HT: 8m45s 2.6.22-rc7, HT: 10m 2.6.22-rc7, non-HT: 6m 2.6.22-rc7+cfs_v18, HT: 10m40s 2.6.22-rc7+cfs_v18, non-HT: 10m45s The "felt" responsiveness was best with the last two kernels, although the load profile over time looks identical in all cases. So, a few questions: a) any idea why disabling HT improves throughput, except for the cfs kernels? For plain 2.6.22 the difference is quite substantial b) any ideas how to optimize the settings of the /proc/sys/vm/ parameters? The documentation is a bit thin here. Thanks in advance Martin ------------------------------------------------------ Martin Knoblauch email: k n o b i AT knobisoft DOT de www: http://www.knobisoft.de - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
