[PATCH 1/5] ARM: dts: at91: nattis: set the PRLUD and HIPOW signals low

[Peter Rosin]

AT91_PINCTRL_OUTPUT_VAL(0) without AT91_PINCTRL_OUTPUT is a no-op, so
make sure the pins really output a zero.

Fixes: 0e4323899973 ("ARM: dts: at91: add devicetree for the Axentia Nattis 
with Natte power")
Signed-off-by: Peter Rosin <p...@axentia.se>
---
 arch/arm/boot/dts/at91-nattis-2-natte-2.dts | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/at91-nattis-2-natte-2.dts 
b/arch/arm/boot/dts/at91-nattis-2-natte-2.dts
index af9f38456d04..bfa5815a0721 100644
--- a/arch/arm/boot/dts/at91-nattis-2-natte-2.dts
+++ b/arch/arm/boot/dts/at91-nattis-2-natte-2.dts
@@ -38,14 +38,16 @@
                                                atmel,pins =
                                                        <AT91_PIOA 21
                                                         AT91_PERIPH_GPIO
-                                                        
AT91_PINCTRL_OUTPUT_VAL(0)>;
+                                                        (AT91_PINCTRL_OUTPUT |
+                                                         
AT91_PINCTRL_OUTPUT_VAL(0))>;
                                        };
 
                                        pinctrl_lcd_hipow0: lcd_hipow0 {
                                                atmel,pins =
                                                        <AT91_PIOA 23
                                                         AT91_PERIPH_GPIO
-                                                        
AT91_PINCTRL_OUTPUT_VAL(0)>;
+                                                        (AT91_PINCTRL_OUTPUT |
+                                                         
AT91_PINCTRL_OUTPUT_VAL(0))>;
                                        };
                                };
                        };
-- 
2.11.0