Add DT bindings for PHY interface built into USB2 controller
implemented on Socionext UniPhier SoCs.
Signed-off-by: Kunihiko Hayashi <hayashi.kunih...@socionext.com>
---
.../devicetree/bindings/phy/uniphier-usb2-phy.txt | 45 ++++++++++++++++++++++
1 file changed, 45 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/uniphier-usb2-phy.txt
diff --git a/Documentation/devicetree/bindings/phy/uniphier-usb2-phy.txt
b/Documentation/devicetree/bindings/phy/uniphier-usb2-phy.txt
new file mode 100644
index 0000000..b43b282
--- /dev/null
+++ b/Documentation/devicetree/bindings/phy/uniphier-usb2-phy.txt
@@ -0,0 +1,45 @@
+Socionext UniPhier USB2 PHY
+
+This describes the devicetree bindings for PHY interface built into
+USB2 controller implemented on Socionext UniPhier SoCs.
+
+Pro4 SoC has both USB2 and USB3 host controllers, however, this USB3
+controller doesn't include its own High-Speed PHY. This needs to specify
+USB2 PHY instead of USB3 HS-PHY.
+
+Required properties:
+- compatible: Should contain one of the following:
+ "socionext,uniphier-pro4-usb2-phy" - for Pro4 SoC
+ "socionext,uniphier-ld11-usb2-phy" - for LD11 SoC
+
+Sub-nodes:
+Each PHY should be represented as a sub-node.
+
+Sub-nodes required properties:
+- #phy-cells: Should be 0.
+- reg: The number of the PHY.
+
+Sub-nodes optional properties:
+- vbus-supply: A phandle to the regulator for USB VBUS.
+
+Refer to phy/phy-bindings.txt for the generic PHY binding properties.
+
+Example:
+ soc-glue@5f800000 {
+ ...
+ usb-phy {
+ compatible = "socionext,uniphier-ld11-usb2-phy";
+ usb_phy0: phy@0 {
+ reg = <0>;
+ #phy-cells = <0>;
+ };
+ ...
+ };
+ };
+
+ usb@5a800100 {
+ compatible = "socionext,uniphier-ehci", "generic-ehci";
+ ...
+ phy-names = "usb";
+ phys = <&usb_phy0>;
+ };
--
2.7.4
