This patch adds the devicetree bindings for Maxim's ds2760 battery monitors.
Signed-off-by: Daniel Mack <dan...@zonque.org> --- .../bindings/power/supply/maxim,ds2760.txt | 26 +++++++++++++++++++ 1 file changed, 26 insertions(+) create mode 100644 Documentation/devicetree/bindings/power/supply/maxim,ds2760.txt diff --git a/Documentation/devicetree/bindings/power/supply/maxim,ds2760.txt b/Documentation/devicetree/bindings/power/supply/maxim,ds2760.txt new file mode 100644 index 000000000000..55967a0bee11 --- /dev/null +++ b/Documentation/devicetree/bindings/power/supply/maxim,ds2760.txt @@ -0,0 +1,26 @@ +Devicetree bindings for Maxim DS2760 +==================================== + +The ds2760 is a w1 slave device and must hence have its sub-node in DT +under a w1 bus master node. + +The device exposes a power supply, so the details described in +Documentation/devicetree/bindings/power/supply/power_supply.txt apply. + +Required properties: +- compatible: must be "maxim,ds2760" + +Optional properties: +- power-supplies: Refers to one or more power supplies connected to + this battery. +- maxim,pmod-enabled: This boolean property enables the DS2760 to enter + sleep mode when the DQ line goes low for greater + than 2 seconds and leave sleep Mode when the DQ + line goes high. +- maxim,cache-time-ms: Time im milliseconds to cache the data for. When + this time expires, the values are read again from + the hardware. Defaults to 1000. +- rated-capacity-microamp-hours: + The rated capacity of the battery, in mAh. + If not specified, the value stored in the + non-volatile chip memory is used. -- 2.17.1
