The field support_vsel is currently only used in the device tree case. Get rid of it. No change in behavior.
Signed-off-by: Stefan Agner <[email protected]> --- drivers/mmc/host/sdhci-esdhc-imx.c | 8 ++------ include/linux/platform_data/mmc-esdhc-imx.h | 2 -- 2 files changed, 2 insertions(+), 8 deletions(-) diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c index 6f444731754d..20a420b765b3 100644 --- a/drivers/mmc/host/sdhci-esdhc-imx.c +++ b/drivers/mmc/host/sdhci-esdhc-imx.c @@ -1145,18 +1145,14 @@ sdhci_esdhc_imx_probe_dt(struct platform_device *pdev, &boarddata->tuning_start_tap); if (of_find_property(np, "no-1-8-v", NULL)) - boarddata->support_vsel = false; - else - boarddata->support_vsel = true; + host->quirks2 |= SDHCI_QUIRK2_NO_1_8_V; if (of_property_read_u32(np, "fsl,delay-line", &boarddata->delay_line)) boarddata->delay_line = 0; mmc_of_parse_voltage(np, &host->ocr_mask); - /* sdr50 and sdr104 need work on 1.8v signal voltage */ - if ((boarddata->support_vsel) && esdhc_is_usdhc(imx_data) && - !IS_ERR(imx_data->pins_default)) { + if (esdhc_is_usdhc(imx_data) && !IS_ERR(imx_data->pins_default)) { imx_data->pins_100mhz = pinctrl_lookup_state(imx_data->pinctrl, ESDHC_PINCTRL_STATE_100MHZ); imx_data->pins_200mhz = pinctrl_lookup_state(imx_data->pinctrl, diff --git a/include/linux/platform_data/mmc-esdhc-imx.h b/include/linux/platform_data/mmc-esdhc-imx.h index 7daa78a2f342..640dec8b5b0c 100644 --- a/include/linux/platform_data/mmc-esdhc-imx.h +++ b/include/linux/platform_data/mmc-esdhc-imx.h @@ -34,7 +34,6 @@ enum cd_types { * @cd_gpio: gpio for card_detect interrupt * @wp_type: type of write_protect method (see wp_types enum above) * @cd_type: type of card_detect method (see cd_types enum above) - * @support_vsel: indicate it supports 1.8v switching */ struct esdhc_platform_data { @@ -43,7 +42,6 @@ struct esdhc_platform_data { enum wp_types wp_type; enum cd_types cd_type; int max_bus_width; - bool support_vsel; unsigned int delay_line; unsigned int tuning_step; /* The delay cell steps in tuning procedure */ unsigned int tuning_start_tap; /* The start delay cell point in tuning procedure */ -- 2.18.0
