Hi!
I have bought recently
00:14.0 Multimedia controller: Philips Semiconductors SAA7134/SAA7135HL Video
Broadcast Decoder (rev 01)
Subsystem: KNC One KNC One TV-Station DVR
Flags: bus master, medium devsel, latency 32, IRQ 11
Memory at d6003000 (32-bit, non-prefetchable) [size=1K]
Capabilities: [40] Power Management version 1
It was very cheap - 12 euro. I couldn't resist because it has hardware MPEG2
video and audio encoder. TV is working OK. I have video and analog audio. But
saa7134-alsa driver wasn't working and audio stream wasn't present in MPEG-TS
stream. After receiving "User guide" from NXP I have started to dig in driver.
Problem is caused by ACNI and ACPF not set before
snd_card_saa7134_capture_prepare().
If I set them manually in this function then DMA capture is starting to working
and audio stream is present in MPEG-TS. Unfortunatly MPlayer can't play audio
from this stream. Also I have to set 32.11MHz as master clock, but driver is
using 24.576MHz for this card? I see that ACNI is set in
saa7134-tvaudio.c/tvaudio_init(). How it gets cleared? I will dig further, but
if somebody has any idea...
Would be OK to make saa7134-empress driver MPlayer compatible? All MPlayer
needs
is audio input (now present) and info about current standard. I see that at
least
one other driver has MPlayer compatibility.
Please CC me.
Rafał
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7134[0]: found at 0000:00:14.0, rev: 1, irq: 11, latency: 32, mmio:
0xd6003000
saa7134[0]: subsystem: 1894:a006, board: KNC One TV-Station DVR
[card=24,autodetected]
saa7134[0]: board init: gpio is 830000
saa7134[0]: i2c eeprom 00: 94 18 06 a0 06 80 00 01 00 00 00 00 00 00 01 00
saa7134[0]: i2c eeprom 10: 00 ff 86 0e ff 20 ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 20: 01 40 01 02 02 03 01 03 06 ff 01 df ff ff ff ff
saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 40: ff 05 00 c0 86 ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7134[0]: i2c eeprom 70: 00 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
tuner 1-0043: chip found @ 0x86 (saa7134[0])
tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner)
tuner 1-0060: All bytes are equal. It is not a TEA5767
tuner 1-0060: chip found @ 0xc0 (saa7134[0])
tuner 1-0060: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
tuner 1-0060: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
saa6752hs 1-0020: saa6752hs: chip found @ 0x40
saa7134[0]: registered device video0 [v4l2]
saa7134[0]: registered device vbi0
saa7134[0]: registered device radio0
----------------------------------------------------------------------
Po meczu.....kurde...:)
>>> http://link.interia.pl/f1a72
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
