>
> ARM should be capitalized in subject line.
OK, will be fixed in v2
>
> > +
> > +&mmc3 {
> > + status = "okay";
> > + /*
> > + * these are on the crossbar and are outlined in the
> > + * xbar-event-map element
> > + */
> > + dmas = <&edma_xbar 30 0 1>,
> > + <&edma_xbar 31 0 2>;
> > + dma-names = "tx", "rx";
> > + vmmc-supply = <&vmmcwl_fixed>;
> > + bus-width = <4>;
> > + pinctrl-names = "default", "sleep";
> > + pinctrl-0 = <&mmc3_pins_default>;
> > + pinctrl-1 = <&mmc3_pins_sleep>;
> > + cap-power-off-card;
> > + keep-power-in-suspend;
> > + ti,non-removable;
> > +
> > + #address-cells = <1>;
> > + #size-cells = <0>;
> > + wlcore: wlcore@0 {
>
> wlcore@2
>
Will be fixed in v2
> > + compatible = "ti,wl1835";
> > + pinctrl-names = "default", "sleep";
> > + pinctrl-0 = <&wlan_pins_default>;
> > + pinctrl-1 = <&wlan_pins_sleep>;
> > + reg = <2>;
> > + interrupt-parent = <&gpio4>;
> > + interrupts = <13 IRQ_TYPE_LEVEL_HIGH>;
> > + };
> > +};
>
Best Regards,
Eyal
