For generic pins, parameter "arg" is 0 or 1.
For special pins, bias-disable is set by R0R1,
so we need transmited "00" to set bias-disable
When we set "bias-disable" as high-z property,
the parameter should be "MTK_PUPD_SET_R1R0_00".
Signed-off-by: Zhiyong Tao <zhiyong....@mediatek.com>
---
drivers/pinctrl/mediatek/pinctrl-mtk-common.c | 8 ++++++--
1 file changed, 6 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
b/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
index 3cf384f..f991ff3 100644
--- a/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
+++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common.c
@@ -293,7 +293,7 @@ static int mtk_pconf_set_pull_select(struct mtk_pinctrl
*pctl,
unsigned int pin, bool enable, bool isup, unsigned int arg)
{
unsigned int bit;
- unsigned int reg_pullen, reg_pullsel;
+ unsigned int reg_pullen, reg_pullsel, r1r0;
int ret;
/* Some pins' pull setting are very different,
@@ -301,8 +301,12 @@ static int mtk_pconf_set_pull_select(struct mtk_pinctrl
*pctl,
* resistor bit, so we need this special handle.
*/
if (pctl->devdata->spec_pull_set) {
+ /* For special pins, bias-disable is set by R1R0,
+ * the parameter should be "MTK_PUPD_SET_R1R0_00".
+ */
+ r1r0 = enable ? arg : MTK_PUPD_SET_R1R0_00;
ret = pctl->devdata->spec_pull_set(mtk_get_regmap(pctl, pin),
- pin, pctl->devdata->port_align, isup, arg);
+ pin, pctl->devdata->port_align, isup, r1r0);
if (!ret)
return 0;
}
--
1.9.1
