On Thu, Feb 22, 2018 at 09:32:09PM +0530, Oza Pawandeep wrote:
> Current DPC driver does not do recovery, e.g. calling end-point's driver's
> callbacks, which sanitize the sw.
> 
> DPC driver implements link_reset callback, and calls pci_do_recovery.
> 
> Signed-off-by: Oza Pawandeep <p...@codeaurora.org>
> 
> diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
> index a5a79f0..124f42e 100644
> --- a/drivers/pci/pci.h
> +++ b/drivers/pci/pci.h
> @@ -343,6 +343,8 @@ static inline resource_size_t 
> pci_resource_alignment(struct pci_dev *dev,
>  void pci_enable_acs(struct pci_dev *dev);
>  
>  /* PCI error reporting and recovery */
> +#define DPC_FATAL    4
> +
>  void pci_do_recovery(struct pci_dev *dev, int severity);
>  
>  #ifdef CONFIG_PCIEASPM
> diff --git a/drivers/pci/pcie/pcie-dpc.c b/drivers/pci/pcie/pcie-dpc.c
> index 38e40c6..208b427 100644
> --- a/drivers/pci/pcie/pcie-dpc.c
> +++ b/drivers/pci/pcie/pcie-dpc.c
> @@ -13,6 +13,7 @@
>  #include <linux/pcieport_if.h>
>  #include "../pci.h"
>  #include "aer/aerdrv.h"
> +#include "portdrv.h"
>  
>  struct dpc_dev {
>       struct pcie_device      *dev;
> @@ -45,6 +46,60 @@ struct dpc_dev {
>       "Memory Request Completion Timeout",             /* Bit Position 18 */
>  };
>  
> +static int find_dpc_dev_iter(struct device *device, void *data)
> +{
> +     struct pcie_port_service_driver *service_driver;
> +     struct device **dev;
> +
> +     dev = (struct device **) data;
> +
> +     if (device->bus == &pcie_port_bus_type && device->driver) {
> +             service_driver = to_service_driver(device->driver);

Please move the initial assignment to the declaration line to
clean this up a bit:

        struct device **dev = (struct device **)data;

Same thing happens a couple more times in this patch.

> +EXPORT_SYMBOL(pci_find_dpc_service);

EXPORT_SYMBOL_GPL for PCI layer internals again - and ditto for
probably about everything in this series.

>  #if IS_ENABLED(CONFIG_PCIEAER)
> -     /* Use the aer driver of the component firstly */
> -     driver = pci_find_aer_service(udev);
> +     if ((severity == AER_FATAL) ||
> +         (severity == AER_NONFATAL) ||
> +         (severity == AER_CORRECTABLE))
> +             driver = pci_find_aer_service(udev);
>  #endif

No need for the inner braces here.

> -     if (severity == AER_FATAL)
> +     if ((severity == AER_FATAL) ||
> +         (severity == DPC_FATAL))
>               state = pci_channel_io_frozen;
>       else
>               state = pci_channel_io_normal;

Same here and a few more times below.

Reply via email to