On 19-01-18, 00:58, Stefan Agner wrote:
> Depending on SKU i.MX6UL/i.MX6ULL support frequencies up to 900MHz.
> Use PLL1 sys clock for all operating points higher than 528MHz.
>
> Note: For higher operating points VDD_SOC_IN needs to be 125mV
> higher than the ARM set-point (see datasheet). Specifically, the
> i.MX6UL/ULL EVK boards have an external DC regulator which needs
> adjustment. The regulator adjustment is not covered with this
> change.
>
> Signed-off-by: Stefan Agner <ste...@agner.ch>
> ---
> drivers/cpufreq/imx6q-cpufreq.c | 14 ++++++++------
> 1 file changed, 8 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/cpufreq/imx6q-cpufreq.c b/drivers/cpufreq/imx6q-cpufreq.c
> index 628fe899cb48..840f6386c780 100644
> --- a/drivers/cpufreq/imx6q-cpufreq.c
> +++ b/drivers/cpufreq/imx6q-cpufreq.c
> @@ -114,12 +114,14 @@ static int imx6q_set_target(struct cpufreq_policy
> *policy, unsigned int index)
> */
> clk_set_rate(arm_clk, (old_freq >> 1) * 1000);
> clk_set_parent(pll1_sw_clk, pll1_sys_clk);
> - if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> - clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> - else
> - clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
> - clk_set_parent(step_clk, secondary_sel_clk);
> - clk_set_parent(pll1_sw_clk, step_clk);
> + if (freq_hz <= clk_get_rate(pll2_bus_clk)) {
> + if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> + clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> + else
> + clk_set_parent(secondary_sel_clk,
> pll2_pfd2_396m_clk);
> + clk_set_parent(step_clk, secondary_sel_clk);
> + clk_set_parent(pll1_sw_clk, step_clk);
> + }
> } else {
> clk_set_parent(step_clk, pll2_pfd2_396m_clk);
> clk_set_parent(pll1_sw_clk, step_clk);
Acked-by: Viresh Kumar <viresh.ku...@linaro.org>
--
viresh
