Re: [RFC] Configuring synchronous interfaces in Linux

[Keith Owens]

On Sat, 2 Dec 2000 13:07:29 -0600 (CST), 
Jeff Garzik <[EMAIL PROTECTED]> wrote:
>If yes, my guess is correct, I think the proper solution is to:
>* create a generic set_config, which does nothing but convert the calls'
>semantics into ethtool semantics, and
>* add ethtool support to the specific driver

cc list trimmed.

If you go down this path, please add a standard performance monitoring
method to query the current capacity of an interface.  It is frustrating
to report "eth0 is handling 1 Megabyte/second, but we cannot tell if
that is 90% (10BaseT) or 9% (100BaseT) utilization".  We should report
capacity rather than speed because speed alone is not the controlling
factor, other things like half or full duplex affect the capacity.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/