Hi! I didn't know which driver was the right one for my network card so I just compiled all network-card drivers that where listed into my kernel I tried it with test9 and test11. The DS21140 Tulip driver found my card and crashes the system during boot up. My card is a Davicom 9102(?). It's working fine with the right driver. I give you the cutted output of lspci -m and lspci -vvv lspci -m: Device: 00:09.0 Class: Ethernet controller Vendor: Davicom Semiconductor, Inc. Device: Ethernet 100/10 MBit SVendor: 1282 SDevice: 9102 Rev: 31 lspci -vvv 00:09.0 Ethernet controller: Davicom Semiconductor, Inc. Ethernet 100/10 MBit (rev 31) Subsystem: Unknown device 4554:434e Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (5000ns min, 10000ns max) Interrupt: pin A routed to IRQ 10 Region 0: I/O ports at 6100 [size=256] Region 1: Memory at f4000000 (32-bit, non-prefetchable) [size=256] Expansion ROM at <unassigned> [disabled] [size=256K] Capabilities: [50] Power Management version 1 Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold+) Status: D0 PME-Enable+ DSel=0 DScale=0 PME- I will send this mail to: [EMAIL PROTECTED] [EMAIL PROTECTED] [EMAIL PROTECTED] I'm not in any of these lists anymore, because the digest service is not offered anymore. :-(% Questions are welcome. Cheers, Udo - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] Please read the FAQ at http://www.tux.org/lkml/
