On Tue, Oct 10, 2017 at 7:30 PM, Jesper Dangaard Brouer
<bro...@redhat.com> wrote:
>
> On Tue, 10 Oct 2017 15:12:31 +0200
> Jesper Dangaard Brouer <bro...@redhat.com> wrote:
>
> > I'll try to test/benchmark your program...
>
> In my initial testing, I cannot get this to work...
>
What is the test setup you are using? So that I can also test
I verified the program in this minimal test setup, I did not see any
issue with the mac addresses being set.
Below is the test setup.
machine 1 machine 2
(90.0.0.2)port 1 ===============>port3(90.0.0.1)
||
(80.0.0.2)port 2<================port4(80.0.0.1)
traffic gen xdp program
Below are the steps followed to run the program.
Assigned ips in different subnets to interfaces 3 and 4
Ip of port 1 is in the same subnet as port 3
Ip of port 2 is in the same subnet as port 4
sysctl -w net.core.bpf_jit_enable=1
./xdp_router_ipv4 eth0 eth1
Note: The program will not generate arp requests. Proper arp entries
need to be added to get the packets forwarded correctly.
> You do seem to XDP_REDIRECT out the right interface, but you have an
> error with setting the correct MAC address.
>
> --
> Best regards,
> Jesper Dangaard Brouer
> MSc.CS, Principal Kernel Engineer at Red Hat
> LinkedIn: http://www.linkedin.com/in/brouer
