The configuration for BCH is not correct in the current
driver so this patch fixed the same.
Signed-off-by: Abhishek Sahu <abs...@codeaurora.org>
---
drivers/mtd/nand/qcom_nandc.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
index 520add9..410ee53 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c
@@ -1919,7 +1919,7 @@ static int qcom_nand_host_setup(struct qcom_nand_host
*host)
| wide_bus << WIDE_FLASH
| 1 << DEV0_CFG1_ECC_DISABLE;
- host->ecc_bch_cfg = host->bch_enabled << ECC_CFG_ECC_DISABLE
+ host->ecc_bch_cfg = !host->bch_enabled << ECC_CFG_ECC_DISABLE
| 0 << ECC_SW_RESET
| host->cw_data << ECC_NUM_DATA_BYTES
| 1 << ECC_FORCE_CLK_OPEN
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of
Code Aurora Forum, hosted by The Linux Foundation
