Steven Cole <[EMAIL PROTECTED]> writes:
> I noticed that for 2.4.0-test11 there is no help
> for CONFIG_TOSHIBA, although there is for 2.2.17.
>
> The following patch borrows the words for CONFIG_TOSHIBA
> from the 2.2.17 Documentation/Configure.help, dropping
> an extraneous "the" from the first line.
>
> This patch applies to 2.4.0-test11.
>
you can apply this too:
--- linux/Documentation/Configure.help.orig Wed Sep 27 03:37:40 2000
+++ linux/Documentation/Configure.help Wed Sep 27 03:39:02 2000
@@ -268,6 +268,11 @@
Most normal users won't need the RAM disk functionality, and can
thus say N here.
+Default RAM disk size
+CONFIG_BLK_DEV_RAM_SIZE
+ The default value is 4096. Only change this if you know what are
+ you doing. If you are using IBM S/390, then set this to 8192.
+
Initial RAM disk (initrd) support
CONFIG_BLK_DEV_INITRD
The initial RAM disk is a RAM disk that is loaded by the boot loader
@@ -14209,6 +14209,11 @@
driver as a module you have to specify the MPU I/O base address with
the parameter 'mpu_base=0xNNN'.
+C-Media PCI (CMI8338/8378)
+CONFIG_SOUND_CMPCI
+ Say Y or M if you have a PCI sound card using the CMI8338
+ or the CMI8378 chip.set.
+
Creative EMU10K1 based PCI sound cards
CONFIG_SOUND_EMU10K1
Say Y or M if you have a PCI sound card using the EMU10K1
--- linux/Documentation/sound/CMI8330.orig Wed Sep 27 03:36:34 2000
+++ linux/Documentation/sound/CMI8330 Wed Sep 27 03:37:09 2000
@@ -57,7 +57,7 @@
------------------------------------------
Stefan Laudat <[EMAIL PROTECTED]>
-[Note: The CMI 8338 is unrelated and right now unsupported]
+[Note: The CMI 8338 is unrelated and is supported by cmpcpi.o]
In order to use CMI8330 under Linux you just have to use a proper
isapnp.conf, a good isapnp and a little bit of patience. I use isapnp 1.17, but
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
