Adding NXP Low Power Timer/Pulse Width Modulation Module (TPM)
binding doc.

Cc: Mark Rutland <mark.rutl...@arm.com>
Cc: devicet...@vger.kernel.org
Cc: Daniel Lezcano <daniel.lezc...@linaro.org>
Cc: Thomas Gleixner <t...@linutronix.de>
Cc: Shawn Guo <shawn...@kernel.org>
Cc: Bai Ping <ping....@nxp.com>
Acked-by: Rob Herring <r...@kernel.org>
Signed-off-by: Dong Aisheng <aisheng.d...@nxp.com>

---
ChangeLog:
 v1->v2:
 * No changes
---
 .../devicetree/bindings/timer/nxp,tpm-timer.txt    | 28 ++++++++++++++++++++++
 1 file changed, 28 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/timer/nxp,tpm-timer.txt

diff --git a/Documentation/devicetree/bindings/timer/nxp,tpm-timer.txt 
b/Documentation/devicetree/bindings/timer/nxp,tpm-timer.txt
new file mode 100644
index 0000000..b4aa7dd
--- /dev/null
+++ b/Documentation/devicetree/bindings/timer/nxp,tpm-timer.txt
@@ -0,0 +1,28 @@
+NXP Low Power Timer/Pulse Width Modulation Module (TPM)
+
+The Timer/PWM Module (TPM) supports input capture, output compare,
+and the generation of PWM signals to control electric motor and power
+management applications. The counter, compare and capture registers
+are clocked by an asynchronous clock that can remain enabled in low
+power modes. TPM can support global counter bus where one TPM drives
+the counter bus for the others, provided bit width is the same.
+
+Required properties:
+
+- compatible : should be "fsl,imx7ulp-tpm"
+- reg :                Specifies base physical address and size of the 
register sets
+               for the clock event device and clock source device.
+- interrupts : Should be the clock event device interrupt.
+- clocks :     The clocks provided by the SoC to drive the timer, must contain
+               an entry for each entry in clock-names.
+- clock-names : Must include the following entries: "igp" and "per".
+
+Example:
+tpm5: tpm@40260000 {
+       compatible = "fsl,imx7ulp-tpm";
+       reg = <0x40260000 0x1000>;
+       interrupts = <GIC_SPI 22 IRQ_TYPE_LEVEL_HIGH>;
+       clocks = <&clks IMX7ULP_CLK_NIC1_BUS_DIV>,
+                <&clks IMX7ULP_CLK_LPTPM5>;
+       clock-names = "ipg", "per";
+};
-- 
2.7.4

Reply via email to