If we have Linux installed in eMMC we can boot without
µSD card, but inserting one is not recognised.
The reason is that the card detect gpio (gpio5_152)
is not configured and attached to the mmc1 interface
driver and the mmc driver does not poll by default.
Hence we add pinmux and gpio setup for the SDCARD_NCD
signal.
Signed-off-by: H. Nikolaus Schaller <h...@goldelico.com>
---
arch/arm/boot/dts/omap5-uevm.dts | 13 +++++++++++++
1 file changed, 13 insertions(+)
diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
index d58b034513da..1a6e28c3d847 100644
--- a/arch/arm/boot/dts/omap5-uevm.dts
+++ b/arch/arm/boot/dts/omap5-uevm.dts
@@ -142,6 +142,13 @@
};
};
+&mmc1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc1_pins>;
+
+ cd-gpios = <&gpio5 24 GPIO_ACTIVE_LOW>; /* gpio5_152 */
+};
+
&omap5_pmx_core {
evm_keys_pins: pinmux_evm_keys_gpio_pins {
pinctrl-single,pins = <
@@ -161,6 +168,12 @@
OMAP5_IOPAD(0x0a8, PIN_INPUT_PULLUP | MUX_MODE6)
/* gpio3_76 */
>;
};
+
+ mmc1_pins: pinmux_mmc1_pins {
+ pinctrl-single,pins = <
+ OMAP5_IOPAD(0x1d4, PIN_INPUT_PULLUP | MUX_MODE6)
/* gpio5_152 */
+ >;
+ };
};
&tpd12s015 {
--
2.12.2
