Andrew Morton a écrit :
The wheel spins around, slows then settles on....
time-smp-friendly-alignment-of-struct-clocksource.patch!
Presumably because the ____cacheline_aligned made vsyscall_gtod_data_t get
too big. Or something.
Very strange, since here I have plenty of available room (256 bytes) :
ffffffffff600000 T vgettimeofday
ffffffffff60004e t vsysc2
ffffffffff600140 t vread_hpet
ffffffffff600150 t vread_tsc
ffffffffff600180 D __vsyscall_gtod_data
ffffffffff600280 D __vgetcpu_mode
ffffffffff6002c0 D __jiffies
<lot of space (256 bytes)>
ffffffffff600400 T vtime
ffffffffff600413 t vsysc1
ffffffffff600800 T vgetcpu
ffffffffff600c00 T venosys_1
It must depends on the compiler, and/or CONFIG_XXX options...
Anyway, I think we can safely move __vgetcpu_mode & __jiffies to the 1024
bytes area dedicated to vgetcpu() implementation. This saves 128 bytes from
vsyscall_0 area.
Could we add this patch instead of dropping
time-smp-friendly-alignment-of-struct-clocksource.patch ?
Thank you
[PATCH] x86_64 : move __vgetcpu_mode & __jiffies to the vsyscall_2 zone
We apparently hit the 1024 limit of vsyscall_0 zone when some debugging
options are set, or if __vsyscall_gtod_data is 64 bytes larger.
In order to save 128 bytes from the vsyscall_0 zone, we move __vgetcpu_mode &
__jiffies to vsyscall_2 zone where they really belong, since they are used
only from vgetcpu() (which is in this vsyscall_2 area).
After patch is applied, new layout is :
ffffffffff600000 T vgettimeofday
ffffffffff60004e t vsysc2
ffffffffff600140 t vread_hpet
ffffffffff600150 t vread_tsc
ffffffffff600180 D __vsyscall_gtod_data
ffffffffff600400 T vtime
ffffffffff600413 t vsysc1
ffffffffff600800 T vgetcpu
ffffffffff600870 D __vgetcpu_mode
ffffffffff600880 D __jiffies
ffffffffff600c00 T venosys_1
Signed-off-by: Eric Dumazet <[EMAIL PROTECTED]>
--- linux-2.6.21-rc5/arch/x86_64/kernel/vmlinux.lds.S
+++ linux-2.6.21-rc5-ed/arch/x86_64/kernel/vmlinux.lds.S
@@ -94,6 +94,12 @@ SECTIONS
{ *(.vsyscall_gtod_data) }
vsyscall_gtod_data = VVIRT(.vsyscall_gtod_data);
+
+ .vsyscall_1 ADDR(.vsyscall_0) + 1024: AT(VLOAD(.vsyscall_1))
+ { *(.vsyscall_1) }
+ .vsyscall_2 ADDR(.vsyscall_0) + 2048: AT(VLOAD(.vsyscall_2))
+ { *(.vsyscall_2) }
+
.vgetcpu_mode : AT(VLOAD(.vgetcpu_mode)) { *(.vgetcpu_mode) }
vgetcpu_mode = VVIRT(.vgetcpu_mode);
@@ -101,10 +107,6 @@ SECTIONS
.jiffies : AT(VLOAD(.jiffies)) { *(.jiffies) }
jiffies = VVIRT(.jiffies);
- .vsyscall_1 ADDR(.vsyscall_0) + 1024: AT(VLOAD(.vsyscall_1))
- { *(.vsyscall_1) }
- .vsyscall_2 ADDR(.vsyscall_0) + 2048: AT(VLOAD(.vsyscall_2))
- { *(.vsyscall_2) }
.vsyscall_3 ADDR(.vsyscall_0) + 3072: AT(VLOAD(.vsyscall_3))
{ *(.vsyscall_3) }
