The BTTV driver 0.7.48 doesn't detect my old Hauppauge card anymore.
The problem seems to be that my card sets PCI_SUBSYSTEM_ID and
PCI_SUBSYSTEM_VENDOR_ID to zero (lspci output below).
In 2.4.0-test10-pre5, the card was correctly detected as a
"Hauppauge old". If I set btv->type to 2 in 2.4.0-test11-pre5, the
card is properly initialized and works.
Not sure what the correct fix is. Maybe to fall back to vendor/device
ID if there's no subsystem information ?
- Werner
---------------------------------- cut here -----------------------------------
# lspci -v -s 00:0f.0
00:0f.0 Multimedia video controller: Brooktree Corporation Bt848 TV with DMA push (rev
12)
Flags: bus master, medium devsel, latency 64, IRQ 9
Memory at eddfe000 (32-bit, prefetchable) [size=4K]
# lspci -x -s 00:0f.0 -n
00:0f.0 Class 0400: 109e:0350 (rev 12)
00: 9e 10 50 03 06 00 80 02 12 00 00 04 00 40 00 00
10: 08 e0 df ed 00 00 00 00 00 00 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
30: 00 00 00 00 00 00 00 00 00 00 00 00 09 01 10 28
--
_________________________________________________________________________
/ Werner Almesberger, ICA, EPFL, CH [EMAIL PROTECTED] /
/_IN_N_032__Tel_+41_21_693_6621__Fax_+41_21_693_6610_____________________/
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
Please read the FAQ at http://www.tux.org/lkml/
