I'm running a e1000xf adapter in a 64-bit/100Mhz PCI slot. The intel
site shows this is a supported config for the card, but linux is pulling
this info:
ed:02.0 Ethernet controller: Intel Corporation 82544EI Gigabit Ethernet
Controller (Fiber) (rev 02)
Subsystem: Intel Corporation PRO/1000 XF Server Adapter
Flags: bus master, 66Mhz, medium devsel, latency 64, IRQ 18
Memory at f7fe0000 (64-bit, non-prefetchable) [size=128K]
Memory at f7fc0000 (64-bit, non-prefetchable) [size=128K]
I/O ports at 7000 [size=32]
[virtual] Expansion ROM at f10a0000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
Capabilities: [e4] PCI-X non-bridge device
Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0
Enable-
My thoughput tests show it is definitely not running at the 100Mhz bus
rate is should be capable of.
Any ideas on how to make it work at full speed?
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
