As the commit 2e63ad4bd5dd ("x86/apic: Do not init irq remapping
if ioapic is disabled") added the judgement of skipped IO APIC
setup at the beginning of enable_IR_x2apic(). It may be redundant
that we check it again when we try to enable the interrupt mapping.
So, remove the one in try_to_enable_IR() and refine them for
better readability.
Signed-off-by: Dou Liyang <douly.f...@cn.fujitsu.com>
---
arch/x86/kernel/apic/apic.c | 17 ++++-------------
1 file changed, 4 insertions(+), 13 deletions(-)
diff --git a/arch/x86/kernel/apic/apic.c b/arch/x86/kernel/apic/apic.c
index 8567c85..86e7bd8 100644
--- a/arch/x86/kernel/apic/apic.c
+++ b/arch/x86/kernel/apic/apic.c
@@ -1610,24 +1610,15 @@ static inline void try_to_enable_x2apic(int remap_mode)
{ }
static inline void __x2apic_enable(void) { }
#endif /* !CONFIG_X86_X2APIC */
-static int __init try_to_enable_IR(void)
-{
-#ifdef CONFIG_X86_IO_APIC
- if (!x2apic_enabled() && skip_ioapic_setup) {
- pr_info("Not enabling interrupt remapping due to skipped
IO-APIC setup\n");
- return -1;
- }
-#endif
- return irq_remapping_enable();
-}
-
void __init enable_IR_x2apic(void)
{
unsigned long flags;
int ret, ir_stat;
- if (skip_ioapic_setup)
+ if (skip_ioapic_setup) {
+ pr_info("Not init interrupt remapping due to skipped IO-APIC
setup\n");
return;
+ }
ir_stat = irq_remapping_prepare();
if (ir_stat < 0 && !x2apic_supported())
@@ -1645,7 +1636,7 @@ void __init enable_IR_x2apic(void)
/* If irq_remapping_prepare() succeeded, try to enable it */
if (ir_stat >= 0)
- ir_stat = try_to_enable_IR();
+ ir_stat = irq_remapping_enable();
/* ir_stat contains the remap mode or an error code */
try_to_enable_x2apic(ir_stat);
--
2.5.5
