On Thu, 16 Feb 2017 10:05:36 +0100 Mariusz Bialonczyk <ma...@skyboo.net> wrote:
> Signed-off-by: Mariusz Bialonczyk <ma...@skyboo.net> > --- > Documentation/w1/slaves/w1_therm | 1 + > 1 file changed, 1 insertion(+) > > diff --git a/Documentation/w1/slaves/w1_therm > b/Documentation/w1/slaves/w1_therm > index d1f93af..e10cd91 100644 > --- a/Documentation/w1/slaves/w1_therm > +++ b/Documentation/w1/slaves/w1_therm > @@ -42,6 +42,7 @@ SRAM, so it is reset when the sensor gets power-cycled. > To store the current precision configuration into EEPROM, the value 0 > has to be written to the sysfs w1_slave file. Since the EEPROM has a limited > amount of writes (>50k), this command should be used wisely. > +Note: this precision value has to be a binary one-byte value, not ASCII. > > The module parameter strong_pullup can be set to 0 to disable the > strong pullup, 1 to enable autodetection or 2 to force strong pullup. > -- > 2.9.3 > Please skip this single patch. I was wrong about it. w1_slave_store is using kstrtoint() so it is currently ok. regards, -- Mariusz Białończyk | xmpp/e-mail: ma...@skyboo.net http://manio.skyboo.net | https://github.com/manio
