Hi Sricharan,
On 10/24/2016 01:18 PM, Sricharan R wrote:
> From: Rajendra Nayak <rna...@codeaurora.org>
>
> Some GDSCs might support a HW control mode, where in the power
> domain (gdsc) is brought in and out of low power state (while
> unsued) without any SW assistance, saving power.
> Such GDSCs can be configured in a HW control mode when powered on
> until they are explicitly requested to be powered off by software.
>
> Signed-off-by: Rajendra Nayak <rna...@codeaurora.org>
> Signed-off-by: Sricharan R <sricha...@codeaurora.org>
> ---
> drivers/clk/qcom/gdsc.c | 15 +++++++++++++++
> drivers/clk/qcom/gdsc.h | 1 +
> 2 files changed, 16 insertions(+)
>
> diff --git a/drivers/clk/qcom/gdsc.c b/drivers/clk/qcom/gdsc.c
> index f12d7b2..a5e1c8c 100644
> --- a/drivers/clk/qcom/gdsc.c
> +++ b/drivers/clk/qcom/gdsc.c
> @@ -55,6 +55,13 @@ static int gdsc_is_enabled(struct gdsc *sc, unsigned int
> reg)
> return !!(val & PWR_ON_MASK);
> }
>
> +static int gdsc_hwctrl(struct gdsc *sc, bool en)
> +{
> + u32 val = en ? HW_CONTROL_MASK : 0;
> +
> + return regmap_update_bits(sc->regmap, sc->gdscr, HW_CONTROL_MASK, val);
> +}
> +
> static int gdsc_toggle_logic(struct gdsc *sc, bool en)
> {
> int ret;
> @@ -164,6 +171,10 @@ static int gdsc_enable(struct generic_pm_domain *domain)
> */
> udelay(1);
>
> + /* Turn on HW trigger mode if supported */
> + if (sc->flags & HW_CTRL)
> + gdsc_hwctrl(sc, true);
Could you check gdsc_hwctrl() for an error.
<cut>
--
regards,
Stan
