From: Thor Thayer <ttha...@opensource.altera.com>
The Designware SPI master requires slave selection before the transfer
can begin [1].
This patch uses the new master flag to indicate both the GPIO CS and
the internal chip select should be used.
Tested On:
Altera CycloneV development kit
Compile tested for build errors on x86_64 (allyesconfigs)
[1] DesignWare dw_apb_ssi Databook, Version 3.20a (page 39)
Signed-off-by: Thor Thayer <ttha...@opensource.altera.com>
---
v3 Use SPI_MASTER_GPIO_SS
---
drivers/spi/spi-dw.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c
index 27960e4..b715a26 100644
--- a/drivers/spi/spi-dw.c
+++ b/drivers/spi/spi-dw.c
@@ -502,6 +502,7 @@ int dw_spi_add_host(struct device *dev, struct dw_spi *dws)
master->handle_err = dw_spi_handle_err;
master->max_speed_hz = dws->max_freq;
master->dev.of_node = dev->of_node;
+ master->flags = SPI_MASTER_GPIO_SS;
/* Basic HW init */
spi_hw_init(dev, dws);
--
1.7.9.5
