Update:
I found out the bad performance was caused by partition alignment, and not by
the pertition per se (YaST created the partition next to the MBR). I compared
two partitions, number one badly aligned, and number 2 properly aligned. Then I
got these results:
Disk /dev/disk/by-id/dm-name-FirstTest-32: 10.7 GB, 10737418240 bytes
64 heads, 32 sectors/track, 10240 cylinders, total 20971520 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 16384 bytes / 16777216 bytes
Disk identifier: 0x00016340
Device Boot Start End Blocks
Id System
/dev/disk/by-id/dm-name-FirstTest-32-part1 1 5242879
2621439+ 83 Linux
Partition 1 does not start on physical sector boundary.
/dev/disk/by-id/dm-name-FirstTest-32-part2 5242880 10485759
2621440 83 Linux
h10:~ # ./flashzap -f -s /dev/disk/by-id/dm-name-FirstTest-32_part1
time to open /dev/disk/by-id/dm-name-FirstTest-32_part1: 0.000021s
time for fstat(): 0.000060s
time to map /dev/disk/by-id/dm-name-FirstTest-32_part1 (size 2684.4MiB) at
0x7f826a8a1000: 0.000038s
time to zap 2684.4MiB: 11.734121s (228.76 MiB/s)
time to sync 2684.4MiB: 3.515991s (763.47 MiB/s)
time to unmap 2684.4MiB at 0x7f826a8a1000: 0.038104s
time to close /dev/disk/by-id/dm-name-FirstTest-32_part1: 0.673100s
h10:~ # ./flashzap -f -s /dev/disk/by-id/dm-name-FirstTest-32_part2
time to open /dev/disk/by-id/dm-name-FirstTest-32_part2: 0.000020s
time for fstat(): 0.000069s
time to map /dev/disk/by-id/dm-name-FirstTest-32_part2 (size 2684.4MiB) at
0x7fe18823e000: 0.000044s
time to zap 2684.4MiB: 4.861062s (552.22 MiB/s)
time to sync 2684.4MiB: 0.811360s (3308.47 MiB/s)
time to unmap 2684.4MiB at 0x7fe18823e000: 0.038380s
time to close /dev/disk/by-id/dm-name-FirstTest-32_part2: 0.265687s
So the correctly aligned partition is two to three times faster than the badly
aligned partition (write-only case), and it's about the performance of an
unpartitioned disk.
Regards,
Ulrich
>>> Ulrich Windl <ulrich.wi...@rz.uni-regensburg.de> schrieb am 30.08.2016 um
>>> 11:32
in Nachricht <57C552B6.33D : 161 : 60728>:
> Hello!
>
> (I'm not subscribed to this list, but I'm hoping to get a reply anyway)
> While testing some SAN storage system, I needed a utility to erase disks
> quickly. I wrote my own one that mmap()s the block device, memset()s the
> area, then msync()s the changes, and finally close()s the file descriptor.
>
> On one disk I had a primary MBR partition spanning the whole disk, like this
> (output from some of my obscure tools):
> disk /dev/disk/by-id/dm-name-FirstTest-32 has 20971520 blocks of size 512
> (10737418240 bytes)
> partition 1 (1-20971520)
> Total Sectors = 20971519
>
> When wiping, I started (for no good reason) to wipe partition 1, then I
> wiped the whole disk. The disk is 4-way multipathed to a 8Gb FC-SAN, and the
> disk system is all-SSD (32x2TB). Using kernel 3.0.101-80-default of SLES11
> SP4.
> For the test I had reduced the amount of RAM via "mem=4G". The machine's RAM
> bandwidth is about 9GB/s.
>
> To my surprise I found out that the partition eats significant performance
> (not quite 50%, but a lot):
>
> ### Partition
> h10:~ # ./flashzap -f -s /dev/disk/by-id/dm-name-FirstTest-32_part1
time to
> open /dev/disk/by-id/dm-name-FirstTest-32_part1: 0.000042s
time for fstat():
> 0.000017s
time to map /dev/disk/by-id/dm-name-FirstTest-32_part1 (size
> 10.7Gib) at 0x7fbc86739000: 0.000039s
time to zap 10.7Gib: 52.474054s (204.62
> MiB/s)
time to sync 10.7Gib: 4.148350s (2588.36 MiB/s)
time to unmap 10.7Gib at
> 0x7fbc86739000: 0.052170s
time to close
> /dev/disk/by-id/dm-name-FirstTest-32_part1: 0.770630s
>
> ### Whole disk
> h10:~ # ./flashzap -f -s /dev/disk/by-id/dm-name-FirstTest-32
time to open
> /dev/disk/by-id/dm-name-FirstTest-32: 0.000022s
time for fstat():
> 0.000061s
time to map /dev/disk/by-id/dm-name-FirstTest-32 (size
> 10.7Gib) at 0x7fa2434cc000: 0.000037s
time to zap 10.7Gib: 24.580162s (436.83
> MiB/s)
time to sync 10.7Gib: 1.097502s (9783.51 MiB/s)
time to unmap 10.7Gib at
> 0x7fa2434cc000: 0.052385s
time to close /dev/disk/by-id/dm-name-FirstTest-32:
> 0.290470s
>
> Reproducible:
> h10:~ # ./flashzap -f -s /dev/disk/by-id/dm-name-FirstTest-32
> time to open /dev/disk/by-id/dm-name-FirstTest-32: 0.000039s
> time for fstat(): 0.000065s
> time to map /dev/disk/by-id/dm-name-FirstTest-32 (size 10.7Gib) at
> 0x7f1cc17ab000: 0.000037s
> time to zap 10.7Gib: 24.624000s (436.06 MiB/s)
> time to sync 10.7Gib: 1.199741s (8949.79 MiB/s)
> time to unmap 10.7Gib at 0x7f1cc17ab000: 0.069956s
> time to close /dev/disk/by-id/dm-name-FirstTest-32: 0.327232s
>
> So without partition the throughput is about twice as high! Why?
>
> Regards
> Ulrich
>
>
