On 08/24/2016 11:56 AM, Stephen Boyd wrote:
> On 08/11, Rajendra Nayak wrote:
>> diff --git a/drivers/clk/qcom/clk-alpha-pll.c 
>> b/drivers/clk/qcom/clk-alpha-pll.c
>> index 2184dc1..68c90f3 100644
>> --- a/drivers/clk/qcom/clk-alpha-pll.c
>> +++ b/drivers/clk/qcom/clk-alpha-pll.c
>> @@ -113,6 +113,11 @@ static int wait_for_pll_offline(struct clk_alpha_pll 
>> *pll, u32 mask)
>>  #define PLL_OFFLINE_ACK             BIT(28)
>>  #define PLL_ACTIVE_FLAG             BIT(30)
>>  
>> +/* alpha pll with dynamic update support */
>> +#define PLL_UPDATE          BIT(22)
>> +#define PLL_HW_LOGIC_BYPASS BIT(23)
>> +#define PLL_ACK_LATCH               BIT(29)
> 
> These need to move next to associated registers.

will do

> 
>> +
>>  void clk_alpha_pll_configure(struct clk_alpha_pll *pll, struct regmap 
>> *regmap,
>>                           const struct alpha_pll_config *config)
>>  {
>> @@ -366,6 +402,7 @@ clk_alpha_pll_recalc_rate(struct clk_hw *hw, unsigned 
>> long parent_rate)
>>  static int clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate,
>>                                unsigned long prate)
>>  {
>> +    int enabled;
> 
> bool

sure

> 
>>      struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
>>      const struct pll_vco *vco;
>>      u32 l, off = pll->offset;
>> @@ -378,6 +415,11 @@ static int clk_alpha_pll_set_rate(struct clk_hw *hw, 
>> unsigned long rate,
>>              return -EINVAL;
>>      }
>>  
>> +    enabled = hw->init->ops->is_enabled(hw);
> 
> We have clk_hw_is_enabled() for this.

sure, will change it to use clk_hw_is_enabled

> 
>> +
>> +    if (!(pll->flags & SUPPORTS_DYNAMIC_UPDATE) && enabled)
>> +            hw->init->ops->disable(hw);
> 
> Please call the function directly instead of going through the
> init structure to get the clk ops.

okay

> 
>> +
>>      a <<= (ALPHA_REG_BITWIDTH - ALPHA_BITWIDTH);
>>  
>>      regmap_write(pll->clkr.regmap, off + PLL_L_VAL, l);
>> @@ -391,6 +433,12 @@ static int clk_alpha_pll_set_rate(struct clk_hw *hw, 
>> unsigned long rate,
>>      regmap_update_bits(pll->clkr.regmap, off + PLL_USER_CTL, PLL_ALPHA_EN,
>>                         PLL_ALPHA_EN);
>>  
>> +    if (!(pll->flags & SUPPORTS_DYNAMIC_UPDATE) && enabled)
>> +            hw->init->ops->enable(hw);
>> +
>> +    if (pll->flags & SUPPORTS_DYNAMIC_UPDATE)
>> +            clk_alpha_pll_dynamic_update(pll);
>> +
> 
> Perhaps write it as
> 
>       if (pll->flags & SUPPORTS_DYNAMIC_UPDATE)
>               clk_alpha_pll_dynamic_update()
>       else if (enabled)
>               toggle the enable bit...

okay will update, thanks
> 

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
hosted by The Linux Foundation

Reply via email to