Ayaz Abdulla wrote: > For all those who are having issues, please try out the attached patch.
Will try. I reverted to 2.6.19 w/o suspend/resume patch last weekend to make sure on 2.6.19 forcedeth is stable and noticed something odd: Because I didn't include the suspend/resume patch I obviously had to a down/rmmod/modprobe/up cycle after each resume and I noticed that the behaviour seems to alternate between resumes: Behaviour 1: After modprobe I get two interface 'eth0' and 'eth1' for the two ports, as expected. Behaviour 2: After modprobe I get one interface 'eth3' (which should be 'eth1') and one interface with increasing numbers (which should be 'eth0', last resume it was 'eth12' IIRC). As I said if I get behaviour 1 on one resume I get behaviour 2 on the next resume and vice versa. That seems rather odd to me. On a not quite related note, forcedeth shows a different ethtool output (compared to e100), when no cable is connected to the port: forcedeth, no cable connected: |Settings for eth1: | Supported ports: [ MII ] | Supported link modes: 10baseT/Half 10baseT/Full | 100baseT/Half 100baseT/Full | 1000baseT/Full | Supports auto-negotiation: Yes | Advertised link modes: 10baseT/Half 10baseT/Full | 100baseT/Half 100baseT/Full | 1000baseT/Full | Advertised auto-negotiation: Yes | Speed: Unknown! (65535) | Duplex: Unknown! (255) | Port: MII | PHYAD: 1 | Transceiver: external | Auto-negotiation: on | Supports Wake-on: g | Wake-on: d | Link detected: no e100, no cable connected: |Settings for eth0: | Supported ports: [ TP MII ] | Supported link modes: 10baseT/Half 10baseT/Full | 100baseT/Half 100baseT/Full | Supports auto-negotiation: Yes | Advertised link modes: 10baseT/Half 10baseT/Full | 100baseT/Half 100baseT/Full | Advertised auto-negotiation: Yes | Speed: 10Mb/s | Duplex: Half | Port: MII | PHYAD: 1 | Transceiver: internal | Auto-negotiation: on | Supports Wake-on: g | Wake-on: g | Current message level: 0x00000007 (7) | Link detected: no Note that e100 returns the lowest possible speed if no link is detected, while forcedeth seems to return -1, which ethtool doesn't seem to recognise as a valid response (I guess, why else would it show the number after 'Unknown!'). -- Tobias PGP: http://9ac7e0bc.uguu.de このメールは十割再利用されたビットで作られています。 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [EMAIL PROTECTED] More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
