[PATCH v0 09/10] net: phy: Re-attempt custom DT configuration after configuration

[Jamie Lentin]

marvell,reg-init is generally used to apply a custom LED configuration
on boot. However this is then blatted in m88e1121_config_aneg when the
interface is brought up. Re-apply any custom configuration afterwards,
to keep custom LED configuration.

Signed-off-by: Jamie Lentin <j...@lentin.co.uk>
---
 drivers/net/phy/marvell.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index c2ca347..b55e4e0 100644
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -424,6 +424,10 @@ static int m88e1121_config_aneg(struct phy_device *phydev)
        phy_write(phydev, MII_MARVELL_PHY_PAGE, oldpage);
 
        err = genphy_config_aneg(phydev);
+       if (err < 0)
+               return err;
+
+       err = marvell_of_reg_init(phydev);
 
        return err;
 }
-- 
2.8.1