According to the datasheet:
SLEW Register(Address = 07h)
b7 b6 b5 b4 b3 b2 b1 b0
48mV/us 42mV/us 36mV/us 30mV/us 24mV/us 18mV/us 12mV/us 6mV/us
Current code does not set correct slew rate in some cases:
e.g. Assume ramp_delay is 10000, current code sets slew register to 6mV/us.
Fix the logic to set slew register.
Signed-off-by: Axel Lin <axel....@ingics.com>
---
drivers/regulator/tps51632-regulator.c | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/drivers/regulator/tps51632-regulator.c
b/drivers/regulator/tps51632-regulator.c
index 572816e..c139890 100644
--- a/drivers/regulator/tps51632-regulator.c
+++ b/drivers/regulator/tps51632-regulator.c
@@ -94,11 +94,14 @@ static int tps51632_dcdc_set_ramp_delay(struct
regulator_dev *rdev,
int ramp_delay)
{
struct tps51632_chip *tps = rdev_get_drvdata(rdev);
- int bit = ramp_delay/6000;
+ int bit;
int ret;
- if (bit)
- bit--;
+ if (ramp_delay == 0)
+ bit = 0;
+ else
+ bit = DIV_ROUND_UP(ramp_delay, 6000) - 1;
+
ret = regmap_write(tps->regmap, TPS51632_SLEW_REGS, BIT(bit));
if (ret < 0)
dev_err(tps->dev, "SLEW reg write failed, err %d\n", ret);
--
2.5.0
