When using DMA, half duplex doesn't work properly because rx is not stopped
before starting tx. Ensure we call atmel_stop_rx() in the DMA case.
Signed-off-by: Alexandre Belloni <alexandre.bell...@free-electrons.com>
---
drivers/tty/serial/atmel_serial.c | 14 ++++++++------
1 file changed, 8 insertions(+), 6 deletions(-)
diff --git a/drivers/tty/serial/atmel_serial.c
b/drivers/tty/serial/atmel_serial.c
index 954941dd8124..f9c798cba83f 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -482,19 +482,21 @@ static void atmel_start_tx(struct uart_port *port)
{
struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
- if (atmel_use_pdc_tx(port)) {
- if (atmel_uart_readl(port, ATMEL_PDC_PTSR) & ATMEL_PDC_TXTEN)
- /* The transmitter is already running. Yes, we
- really need this.*/
- return;
+ if (atmel_use_pdc_tx(port) && (atmel_uart_readl(port, ATMEL_PDC_PTSR)
+ & ATMEL_PDC_TXTEN))
+ /* The transmitter is already running. Yes, we
+ really need this.*/
+ return;
+ if (atmel_use_pdc_tx(port) || atmel_use_dma_tx(port))
if ((port->rs485.flags & SER_RS485_ENABLED) &&
!(port->rs485.flags & SER_RS485_RX_DURING_TX))
atmel_stop_rx(port);
+ if (atmel_use_pdc_tx(port))
/* re-enable PDC transmit */
atmel_uart_writel(port, ATMEL_PDC_PTCR, ATMEL_PDC_TXTEN);
- }
+
/* Enable interrupts */
atmel_uart_writel(port, ATMEL_US_IER, atmel_port->tx_done_mask);
}
--
2.8.1
