On 02/05/16 13:17, Laxman Dewangan wrote: > The IO pins of Tegra SoCs are grouped for common control of IO > interface like setting voltage signal levels and power state of > the interface. The group is generally referred as IO pads. The > power state and voltage control of IO pins can be done at IO pads > level. > > Before Tegra210, the voltage level of IO rails are auto detected and > configure IO pads accordingly but on T210, it is require to set > explicitly by SW. > > This series: > - add public APIs from Tegra PMC interface for io pads control > for power state and voltage levels. > - Add pincontrol driver to use these APIs to configure the IO > pads voltage and power state. > > --- > Changes from V1: > - Use pinconfig generic property for power enable/disable. > - Rename power-source-voltage properties. > - Make all register read/write value to u32. > - Add IO pads macros and APIs which is nearest definiton of HW blocks.
Nit ... if this is a V2 it should be stated in the subject. Jon
