On 27/04/16 09:04, H. Nikolaus Schaller wrote:

Am 26.04.2016 um 19:27 schrieb Tony Lindgren <t...@atomide.com>:

Tero,

* H. Nikolaus Schaller <h...@goldelico.com> [160418 11:23]:
OMAP5 has a register to control if the ckobuffer is enabled
and defines the polarity. ckobuffer is required to drive a twl6040
with the system clock. Hence, add the pinctrl,single to the
OMAP5 SoC description so that omap5-board-common can
set up the ckobuffer as required.

Is this really a mux or should it be a mux clock?

It is a pinmux setting for the clock out buffer to choose what signal
(and polarity) is presented on the fref_xtal_clk pad.

The register is part of the CTRL_MODULE_WKUP.
The clock signal is the xtal master clock of the whole SoC.

Although there is a bit to choose an alternate clock, there is no
alternate in the OMAP5 silicon.

Therefore I would say it is about padconf and not clock or clock mux
related.

It just happens to be a clock signal which can be routed to this
pad.

The two could very well be implemented as clock nodes, a mux and a gate. This would describe the hardware functionality better imo, if the assumptions made here are correct. Implementing the control as pinctrl hacks looks rather weird to me.

I could not find any documentation related to the ckobuffer usage though, maybe Peter can provide some insight? I think you spent some considerable time bringing up twl6040 a few years back...

-Tero


BR,
Nikolaus


Regards,

Tony

Signed-off-by: H. Nikolaus Schaller <h...@goldelico.com>
---
arch/arm/boot/dts/omap5.dtsi | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
index 120b6b8..1d9050f 100644
--- a/arch/arm/boot/dts/omap5.dtsi
+++ b/arch/arm/boot/dts/omap5.dtsi
@@ -277,6 +277,16 @@
                                pinctrl-single,register-width = <16>;
                                pinctrl-single,function-mask = <0x7fff>;
                        };
+
+                       omap5_control_ckobuffer: pinmux@cdb4 {
+                               compatible = "ti,omap5-padconf",
+                                            "pinctrl-single";
+                               reg = <0xcdb4 4>;
+                               #address-cells = <1>;
+                               #size-cells = <0>;
+                               pinctrl-single,register-width = <32>;
+                               pinctrl-single,function-mask = <0xf0000000>;
+                       };
                };

                ocmcram: ocmcram@40300000 {
--
2.7.3



Reply via email to