On 2016年03月16日 03:56, Eduardo Valentin wrote:
> * PGP Signed by an unknown key
>
> On Tue, Mar 15, 2016 at 02:21:53PM +0800, Wei Ni wrote:
>>
>>
>> On 2016年03月15日 04:05, Eduardo Valentin wrote:
>>>> Old Signed by an unknown key
>>>
>>> On Fri, Mar 11, 2016 at 11:09:14AM +0800, Wei Ni wrote:
>>>> Get rid of T124-specific PDIV/HOTSPOT hack.
>>>> tegra-soctherm.c contained a hack to set the SENSOR_PDIV and
>>>> SENSOR_HOTSPOT_OFFSET registers - it just did two writes of
>>>> T124-specific opaque values. Convert these into a form that can be
>>>> substituted on a per-chip basis, and into structure fields that have
>>>> at least some independent meaning.
>>>>
>>>> Signed-off-by: Wei Ni <w...@nvidia.com>
>>>> ---
>>>> drivers/thermal/tegra/tegra-soctherm.c | 18 ++++++++++++++----
>>>> 1 file changed, 14 insertions(+), 4 deletions(-)
>>>>
>>>> diff --git a/drivers/thermal/tegra/tegra-soctherm.c
>>>> b/drivers/thermal/tegra/tegra-soctherm.c
>>>> index b3ec0faa2bee..b4b791ebfbb6 100644
>>>> --- a/drivers/thermal/tegra/tegra-soctherm.c
>>>> +++ b/drivers/thermal/tegra/tegra-soctherm.c
>>>> @@ -48,14 +48,12 @@
>>>> #define SENSOR_CONFIG2_THERMB_SHIFT 0
>>>>
>>>> #define SENSOR_PDIV 0x1c0
>>>> -#define SENSOR_PDIV_T124 0x8888
>>>> #define SENSOR_PDIV_CPU_MASK (0xf << 12)
>>>> #define SENSOR_PDIV_GPU_MASK (0xf << 8)
>>>> #define SENSOR_PDIV_MEM_MASK (0xf << 4)
>>>> #define SENSOR_PDIV_PLLX_MASK (0xf << 0)
>>>>
>>>> #define SENSOR_HOTSPOT_OFF 0x1c4
>>>> -#define SENSOR_HOTSPOT_OFF_T124 0x00060600
>>>> #define SENSOR_HOTSPOT_CPU_MASK (0xff << 16)
>>>> #define SENSOR_HOTSPOT_GPU_MASK (0xff << 8)
>>>> #define SENSOR_HOTSPOT_MEM_MASK (0xff << 0)
>>>> @@ -436,6 +434,7 @@ static int tegra_soctherm_probe(struct platform_device
>>>> *pdev)
>>>> struct resource *res;
>>>> unsigned int i;
>>>> int err;
>>>> + u32 pdiv, hotspot;
>>>>
>>>> const struct tegra_tsensor *tsensors = t124_tsensors;
>>>> const struct tegra_tsensor_group **ttgs = tegra124_tsensor_groups;
>>>> @@ -493,8 +492,19 @@ static int tegra_soctherm_probe(struct
>>>> platform_device *pdev)
>>>> goto disable_clocks;
>>>> }
>>>>
>>>> - writel(SENSOR_PDIV_T124, tegra->regs + SENSOR_PDIV);
>>>> - writel(SENSOR_HOTSPOT_OFF_T124, tegra->regs + SENSOR_HOTSPOT_OFF);
>>>> + /* Program pdiv and hotspot offsets per THERM */
>>>> + pdiv = readl(tegra->regs + SENSOR_PDIV);
>>>> + hotspot = readl(tegra->regs + SENSOR_HOTSPOT_OFF);
>>>> + for (i = 0; i < TEGRA124_SOCTHERM_SENSOR_NUM; ++i) {
>>>> + pdiv = REG_SET_MASK(pdiv, ttgs[i]->pdiv_mask,
>>>> + ttgs[i]->pdiv);
>>>> + if (ttgs[i]->id != TEGRA124_SOCTHERM_SENSOR_PLLX)
>>>> + hotspot = REG_SET_MASK(hotspot,
>>>> + ttgs[i]->pllx_hotspot_mask,
>>>> + ttgs[i]->pllx_hotspot_diff);
>>>> + }
>>>> + writel(pdiv, tegra->regs + SENSOR_PDIV);
>>>> + writel(hotspot, tegra->regs + SENSOR_HOTSPOT_OFF);
>>>
>>> Is the above logic the same for all supported chips? e.g. do we always
>>> skip pllx for hotspot configuration?
>>
>> Yes, this logic support Tegra124, Tegra210, and Tegra132 which I will send
>> out
>> in next series.
>
>
> Ok. Could you please add a comment then explaining why pllx is not
> needed for the hotspot configuration?
This is the hotspot offset from PLLX, so we doesn't need to configure for PLLX,
the Tegra DRM introduced it.
I will add comment for it.
>
>>
>>>
>>>
>>>>
>>>> /* Initialize thermctl sensors */
>>>>
>>>> --
>>>> 1.9.1
>>>>
>>>
>>> * Unknown Key
>>> * 0x7DA4E256
>>>
>
> * Unknown Key
> * 0x7DA4E256
>
