Hi Andy,
Andy Shevchenko 於 2016/2/23 下午 07:05 寫道:
On Tue, 2016-02-23 at 14:30 +0800, Peter Hung wrote:
+config MFD_FINTEK_F81504_CORE
+ tristate "Fintek F81504/508/512 PCIE-to-UART/GPIO MFD
support"
+ depends on PCI
+ select MFD_CORE
+ default SERIAL_8250
SERIAL_8250_PCI ?
In my opinion, 8250_pci & f81504_core are independently drivers.
So I'll set the default to SERIAL_8250.
+static bool f81504_is_gpio(unsigned int idx, u8 gpio_en)
+{
+ unsigned int i;
+
+ /* Find every port to check is multi-function port */
+ for (i = 0; i < ARRAY_SIZE(fintek_gpio_mapping); i++) {
+ if (fintek_gpio_mapping[i] != idx || !(gpio_en &
BIT(i)))
+ continue;
+
+ /*
+ * This port is multi-function and enabled as gpio
mode.
+ * So we'll not configure it as serial port.
+ */
+ return true;
Perhaps
if (fintek_gpio_mapping[i] == idx && (gpio_en & BIT(i)))
return true;
Your code is more simple and readable. I'll change it for V5
Thanks for your advices.
--
With Best Regards,
Peter Hung
