The current code to initialize, register and read the clocksource is
already factored out in mmio.c via the clocksource_mmio_init function.
The only difference is the readl vs readl_relaxed.
Factor out the code with the clocksource_mmio_init function.
Signed-off-by: Daniel Lezcano <daniel.lezc...@linaro.org>
---
drivers/clocksource/timer-sun5i.c | 16 ++--------------
1 file changed, 2 insertions(+), 14 deletions(-)
diff --git a/drivers/clocksource/timer-sun5i.c
b/drivers/clocksource/timer-sun5i.c
index bca9573..dc3793c 100644
--- a/drivers/clocksource/timer-sun5i.c
+++ b/drivers/clocksource/timer-sun5i.c
@@ -152,13 +152,6 @@ static irqreturn_t sun5i_timer_interrupt(int irq, void
*dev_id)
return IRQ_HANDLED;
}
-static cycle_t sun5i_clksrc_read(struct clocksource *clksrc)
-{
- struct sun5i_timer_clksrc *cs = to_sun5i_timer_clksrc(clksrc);
-
- return ~readl(cs->timer.base + TIMER_CNTVAL_LO_REG(1));
-}
-
static int sun5i_rate_cb_clksrc(struct notifier_block *nb,
unsigned long event, void *data)
{
@@ -217,13 +210,8 @@ static int __init sun5i_setup_clocksource(struct
device_node *node,
writel(TIMER_CTL_ENABLE | TIMER_CTL_RELOAD,
base + TIMER_CTL_REG(1));
- cs->clksrc.name = node->name;
- cs->clksrc.rating = 340;
- cs->clksrc.read = sun5i_clksrc_read;
- cs->clksrc.mask = CLOCKSOURCE_MASK(32);
- cs->clksrc.flags = CLOCK_SOURCE_IS_CONTINUOUS;
-
- ret = clocksource_register_hz(&cs->clksrc, rate);
+ ret = clocksource_mmio_init(base + TIMER_CNTVAL_LO_REG(1), node->name,
+ rate, 340, UINT_MAX,
clocksource_mmio_readw_down);
if (ret) {
pr_err("Couldn't register clock source.\n");
goto err_remove_notifier;
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majord...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
