Hi all, my system keeps rebooting without motivation. During the reboots XF4.01 was running and a compile job in the backround. System is a AMD duron which is overclocked to (600) 800. However this system was running fine the last days throughout with earlier test9 kernels. So I guess this is not the reason. System was rebooting no matter if kernel was compiled for i386 or Athlon. Please see attached information. Greetings Michael PS: At least it is not eating my filesystem like in those ancient 2.3.xx days.
Linux version 2.4.0-test9 (root@HAL) (gcc version 2.95.2 19991024 (release)) #3 Mit Sep 27 23:38:29 CEST 2000 BIOS-provided physical RAM map: BIOS-e820: 000000000009fc00 @ 0000000000000000 (usable) BIOS-e820: 0000000000000400 @ 000000000009fc00 (reserved) BIOS-e820: 0000000000010000 @ 00000000000f0000 (reserved) BIOS-e820: 0000000000010000 @ 00000000ffff0000 (reserved) BIOS-e820: 0000000007f00000 @ 0000000000100000 (usable) On node 0 totalpages: 32768 zone(0): 4096 pages. zone(1): 28672 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=linux ro root=805 agp_try_unsupported=1 Initializing CPU#0 Detected 800.039 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1595.80 BogoMIPS Memory: 126084k/131072k available (1778k kernel code, 4600k reserved, 137k data, 216k init, 0k highmem) Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes) Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes) Page-cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) VFS: Diskquotas version dquot_6.4.0 initialized CPU: L1 I Cache: 64K L1 D Cache: 64K (64 bytes/line) CPU: L2 Cache: 64K CPU: AMD Duron(tm) Processor stepping 00 Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.36 (20000221) Richard Gooch ([EMAIL PROTECTED]) PCI: PCI BIOS revision 2.10 entry at 0xfb250, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware isapnp: Scanning for Pnp cards... isapnp: No Plug & Play device found Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 1024 buckets, 8Kbytes TCP: Hash tables configured (established 8192 bind 8192) Initializing RT netlink socket Starting kswapd v1.8 0x378: FIFO is 16 bytes 0x378: writeIntrThreshold is 8 0x378: readIntrThreshold is 8 0x378: PWord is 8 bits 0x378: Interrupts are ISA-Pulses 0x378: possible IRQ conflict! 0x378: ECP port cfgA=0x10 cfgB=0x00 0x378: ECP settings irq=<none or set by other means> dma=<none or set by other means> parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA] parport0: cpp_daisy: aa5500ff(00) parport0: assign_addrs: aa5500ff(00) parport0: No more nibble data (0 bytes) parport0: cpp_daisy: aa5500ff(00) parport0: assign_addrs: aa5500ff(00) parport0: Legacy device parport_pc: Via 686A parallel port: io=0x378, irq=7, dma=3 i2c-core.o: i2c core module i2c-dev.o: i2c /dev entries driver module i2c-core.o: driver i2c-dev dummy driver registered. pty: 256 Unix98 ptys configured lp0: using parport0 (interrupt-driven). RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller on PCI bus 00 dev 39 VP_IDE: chipset revision 16 VP_IDE: not 100% native mode: will probe irqs later VP_IDE: neither IDE port enabled (BIOS) Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Loading I2O Core - (c) Copyright 1999 Red Hat Software Linux I2O PCI support (c) 1999 Red Hat Software. i2o: Checking for PCI I2O controllers... I2O configuration manager v 0.04. (C) Copyright 1999 Red Hat Software I2O Block Storage OSM v0.9 (c) Copyright 1999, 2000 Red Hat Software. I2O LAN OSM (C) 1999 University of Helsinki. Serial driver version 5.02 (2000-08-09) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A Real Time Clock Driver v1.10c 8139too Fast Ethernet driver 0.9.10 loaded eth0: RealTek RTL8139 Fast Ethernet at 0xc8800000, 00:e0:7d:72:d3:80, IRQ 11 eth0: Identified 8139 chip type 'RTL-8139A' atp.c:v1.09 8/9/2000 Donald Becker <[EMAIL PROTECTED]> http://www.scyld.com/network/atp.html Linux agpgart interface v0.99 (c) Jeff Hartmann agpgart: Maximum main memory to use for agp memory: 96M agpgart: Detected Via Apollo Pro KT133 chipset agpgart: AGP aperture is 64M @ 0xd0000000 (scsi0) <Adaptec AHA-294X Ultra SCSI host adapter> found at PCI 0/14/0 (scsi0) Wide Channel, SCSI ID=7, 16/255 SCBs (scsi0) Downloading sequencer code... 422 instructions downloaded scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0 <Adaptec AHA-294X Ultra SCSI host adapter> (scsi0:0:0:0) Synchronous at 40.0 Mbyte/sec, offset 8. Vendor: IBM Model: DDRS-39130D Rev: DC1B Type: Direct-Access ANSI SCSI revision: 02 (scsi0:0:1:0) Synchronous at 10.0 Mbyte/sec, offset 15. Vendor: TEAC Model: CD-R56S4 Rev: 1.0N Type: CD-ROM ANSI SCSI revision: 02 (scsi0:0:2:0) Synchronous at 20.0 Mbyte/sec, offset 8. Vendor: PIONEER Model: DVD-ROM DVD-303 Rev: 1.09 Type: CD-ROM ANSI SCSI revision: 02 (scsi0:0:4:0) Synchronous at 5.0 Mbyte/sec, offset 8. Vendor: HP Model: HP35480A Rev: T503 Type: Sequential-Access ANSI SCSI revision: 02 Detected scsi tape st0 at scsi0, channel 0, id 4, lun 0 st: bufsize 32768, wrt 30720, max init. buffers 4, s/g segs 16. Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 SCSI device sda: 17850000 512-byte hdwr sectors (9139 MB) Partition check: sda: sda1 sda1 sda2 sda2 < sda5 sda5 sda6 sda6 > Detected scsi CD-ROM sr0 at scsi0, channel 0, id 1, lun 0 Detected scsi CD-ROM sr1 at scsi0, channel 0, id 2, lun 0 sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.11 sr1: scsi3-mmc drive: 0x/0x cd/rw xa/form2 cdda tray Via 686a audio driver 1.1.8 ac97_codec: AC97 audio codec, id: 0x4943:0x4511 (Unknown) via82cxxx: board #1 at 0xDC00, IRQ 11 Linux PCMCIA Card Services 3.1.20 options: [pci] [cardbus] md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12 md.c: sizeof(mdp_super_t) = 4096 ds: no socket drivers loaded! VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 216k freed Adding Swap: 265032k swap-space (priority -1)
-- Versions installed: (if some fields are empty or look -- unusual then possibly you have very old versions) Linux HAL 2.4.0-test9 #3 Mit Sep 27 23:38:29 CEST 2000 i686 unknown Kernel modules 2.3.14 Gnu C 2.95.2 Gnu Make 3.78.1 Binutils 2.9.5.0.22 Linux C Library 2.1.3 Dynamic linker ldd (GNU libc) 2.1.3 Procps 2.0.6 Mount 2.10f Net-tools 1.54 Console-tools 0.3.3 Sh-utils 2.0 Modules Loaded
